Abstract:In order to study the underground coal-gasification process, Aspen Plus software was used to simulate the lignite underground gasification process, and a variety of unit operation modules were selected and combined with the kinetic equations of coal underground gasification. The model can reflect the complete gasification process of the coal underground gasifier well, and the simulation results are more in line with the experimental results of the lignite underground gasification model test. The changes in the temperature and pressure of oxygen, gasification water, spray water, and syngas in pipelines were studied, and the effects of pipe diameters on pipeline conveying performance were investigated as well. The effects of the oxygen/water ratio, processing capacity, and spray-water volume on the components of syngas and components in different reaction zones were studied. In addition, the change tendency of gasification products under different conditions was researched. The results indicate that: (1) The depth of injection and the formation pressure at that depth need to be taken into account to determine a reasonable injection pressure. (2) The liquid-water injection process should select a lower injection pressure. (3) Increasing the oxygen/water ratio favors H2 production and decreasing the oxygen/water ratio favors CH4 production. (4) The content of CO2 is the highest in the oxidation zone, the lowest in the reduction zone, and then increases a little in the methanation reaction zone for the transform reaction. The content of CO is the lowest in the oxidation zone and the highest in the reduction zone. In the methanation reaction zone, CO partially converts into H2 and CO2, and the content of CO is reduced. (5) The injection of spray water does not affect the components of the gas but will increase the water vapor content in the gas; thus, this changes the molar fraction of the wet gas.

Simulation Analysis of Ammonia Distribution in Methanol Production from Coal Water Slurry Gasification

Modeling, Simulation and Optimization of a Whole Industrial Catalytic Naphtha Reforming Process on Aspen Plus Platform

Simulation of Industrial Catalytic Reforming Process by Developing User's Module on ASPEN PLUS Platform

Simulation and analysis of coal based syngas methanation process based on Aspen Plus

Simulation of Underground Coal-Gasification Process Using Aspen Plus

Comparison and Analysis of Mainstream Methanation Process of Coal-to-SNG Based on Simulation by Aspen Plus

System simulation of Co-feed and Co-generation system based on the syngas

Thermodynamic simulation of methanol synthesis from biomass-derived syngas

Simulation of Process for Preparing Sodium Methoxide Using Aspen Plus

Simulation Optimization of A New Ammonia-Based Carbon Capture Process Coupled with Low-Temperature Waste Heat Utilization

Simulation study on comprehensive thermal treatment of oil sludge based on Aspen plus

Simulation and modeling of hydrogen production and power from wheat straw biomass at supercritical condition through Aspen Plus and ANN approaches

Aspen Simulation Study of Dual-Fluidized Bed Biomass Gasification

Study on the Simulation of Source-Separated Combustible Solid Waste Fluidized Bed Gasification Based on Aspen Plus

Feasibility and Performance Analysis of a Dual‐Regulation System in the Process of Methanol and Electricity Coproduction by Coal Gasification

Application of the Aspen Plus Software Package for Simulation of the Synthesis-Gas Composition in Oxygen-Free Steam Gasification of Biomass

Simulation of CO2 capture using ammonia scrubbing: A comparison with MEA scrubbing

Simulation Analysis and Optimization of Steam Reforming Process for A Large-Scale Ammonia Plant

Numerical Simulation of the Effect of Coal-Water-Slurry's Concentration on its Gasification Process

Simulation of Municipal Solid Waste Gasification for Syngas Production in Fixed Bed Reactors

Study on Coal Water Slurries Prepared from Coal Chemical Wastewater and Their Industrial Application