Simulation of Underground Coal-Gasification Process Using Aspen Plus

Shuxia Yuan,Wanwan Jiao,Chuangye Wang,Song Wu,Qibin Jiang
DOI: https://doi.org/10.3390/en17071619
IF: 3.2
2024-03-29
Energies
Abstract:In order to study the underground coal-gasification process, Aspen Plus software was used to simulate the lignite underground gasification process, and a variety of unit operation modules were selected and combined with the kinetic equations of coal underground gasification. The model can reflect the complete gasification process of the coal underground gasifier well, and the simulation results are more in line with the experimental results of the lignite underground gasification model test. The changes in the temperature and pressure of oxygen, gasification water, spray water, and syngas in pipelines were studied, and the effects of pipe diameters on pipeline conveying performance were investigated as well. The effects of the oxygen/water ratio, processing capacity, and spray-water volume on the components of syngas and components in different reaction zones were studied. In addition, the change tendency of gasification products under different conditions was researched. The results indicate that: (1) The depth of injection and the formation pressure at that depth need to be taken into account to determine a reasonable injection pressure. (2) The liquid-water injection process should select a lower injection pressure. (3) Increasing the oxygen/water ratio favors H2 production and decreasing the oxygen/water ratio favors CH4 production. (4) The content of CO2 is the highest in the oxidation zone, the lowest in the reduction zone, and then increases a little in the methanation reaction zone for the transform reaction. The content of CO is the lowest in the oxidation zone and the highest in the reduction zone. In the methanation reaction zone, CO partially converts into H2 and CO2, and the content of CO is reduced. (5) The injection of spray water does not affect the components of the gas but will increase the water vapor content in the gas; thus, this changes the molar fraction of the wet gas.
energy & fuels
What problem does this paper attempt to address?
The main problem that this paper attempts to solve is to simulate the underground coal seam gasification process by using Aspen Plus software in order to better understand and optimize this complex technology. Specifically, the research aims to: 1. **Establish a reliable simulation model**: Use Aspen Plus software, combined with multiple unit operation modules and the kinetic equations of underground coal gasification, to construct a simulation model that can reflect the complete underground coal seam gasification process. 2. **Study the pipeline transportation performance**: Explore the temperature and pressure changes of oxygen, gasification water, spray water and syngas in the pipeline, especially the influence of different pipe diameters on the pipeline transportation performance. 3. **Analyze the influence of process parameters**: Study the influence of factors such as the oxygen/water ratio, treatment capacity and spray water volume on the syngas composition and the composition of different reaction zones. 4. **Optimize the gasification process**: Provide references for the actual underground coal seam gasification process through simulation results, and optimize key parameters in the gasification process, such as the selection of reasonable injection pressure and liquid water injection pressure. 5. **Reveal the change trend of gasification products**: Study the change trend of gasification products under different conditions. For example, increasing the oxygen/water ratio is conducive to the generation of hydrogen (H₂), while reducing the oxygen/water ratio is conducive to the generation of methane (CH₄). ### Specific problem analysis - **Reasonable injection pressure**: Research shows that the injection depth and the formation pressure at this depth need to be comprehensively considered to determine the reasonable injection pressure. - **Liquid water injection pressure**: The injection of liquid water should choose a lower injection pressure. - **Influence of oxygen/water ratio**: Increasing the oxygen/water ratio is conducive to the generation of H₂, while reducing the oxygen/water ratio is conducive to the generation of CH₄. - **Change of reaction zone composition**: - The CO₂ content is the highest in the oxidation zone, the lowest in the reduction zone, and then slightly increases in the methanation reaction zone. - The CO content is the lowest in the oxidation zone and the highest in the reduction zone; in the methanation reaction zone, part of CO is converted into H₂ and CO₂, resulting in a decrease in CO content. - **Influence of spray water**: The injection of spray water will not affect the gas composition, but will increase the water vapor content in the gas, thus changing the mole fraction of the wet gas. Through these studies, the paper provides important theoretical support and technical references for the development of underground coal seam gasification technology.