Observation on the Oxidation of Liquid Al by Environmental Transmission Electron Microscope

Cai Jun,Ling Guoping,Chen Changan,Zhang Guikai
DOI: https://doi.org/10.3724/sp.j.1037.2013.00165
IF: 1.797
2013-01-01
ACTA METALLURGICA SINICA
Abstract:The study of liquid metal oxidation is of particular importance since some liquid metals are highly reactive with oxygen even under ultrahigh vacuum. The investigation of the oxidation behavior of liquid aluminum is strongly demanded due to its wide applications but relatively low melting point. However, it is still ambiguous about the products at the initial oxidation stage of liquid aluminum through the researches done in the past several decades. In order to investigate the initial oxidation products together with the oxidation mechanism of liquid aluminum, in-situ oxidation of nano aluminum powder was carried out at 720 degrees C in the environmental TEM (E-TEM). Prior to the oxidation, the nano aluminum powder was visualized and analyzed by E-TEM and DTA respectively. The results show that there is an amorphous Al2O3 film of 5-6 nm thick on the surface of the aluminum powder, which transforms to gamma-Al2O3 at a temperature range of 350-550 degrees C. By melting the nano powder to liquid followed by cooling under a total pressure of 10(-4) Pa in E-TEM, oxide-free solid aluminum is obtained. Re-melting of the solid aluminum at 720 degrees C yields oxide-free liquid aluminum. After oxidation of the oxide-free liquid aluminum under an oxygen partial pressure of 10(-2) Pa in E-TEM, alpha-Al2O3 nano wires appear on the liquid aluminum surface, demonstrating that the initial oxidation product of liquid aluminum is alpha-Al2O3. Moreover, the oxidation of liquid aluminum prepared from oxide-free bulk aluminum at 720 degrees C under an oxygen partial pressure of 10(-2) Pa was also studied. The XRD analysis of the products confirms that the oxide is constituted of single alpha-Al2O3. Additionally, this particular oxidation result of liquid aluminum is attributed to its liquid structure and vapor oxidation process.
What problem does this paper attempt to address?