Abstract:Abstract High-temperature heat pipe is an ideal technical solution for microreactors applied for space missions, planet surface, and the small electricity markets on the ground. However, the internal fluid flow state and the effects of key parameters such as permeability, porosity, and capillary force of wick structure on the distribution of working fluid inside the heat pipe are difficult to measure experimentally. In this study, a general CFD model for heat pipe with wick structure that can predict the thermal behavior at different steady-state conditions was carried out. The thermal conduction through heat pipe shell, liquid film on the inner surface, and the formation of liquid reservoir at the bottom of heat pipe were considered in this model. A high-temperature heat pipe model considering the flow of liquid working fluid inside the wick structure was developed based on the Star-CCM+ numerical simulation software. The model used a combination of the liquid film model and the Volume of Fluid (VOF) model to simulate the effects of fluid flow and collection behavior inside the wick structure on the heat transfer characteristics of the heat pipe. The method included models for flow resistance and capillary driving force under steady-state conditions, centrifugal force and time-varying gravitational field under motion conditions, and mixed convective heat transfer caused by motion conditions. The accuracy of the numerical simulation was validated using typical potassium high-temperature heat pipe experiments. The effects of different permeability and capillary force characteristics of the wick structure on heat transfer and internal fluid distribution in the heat pipe were studied. Based on the current method, high-temperature heat pipes with different inclinations (0°, 90 °and 45°) were investigated. Additionally, non-uniform heating boundary conditions were added to the high-temperature heat pipe evaporator section to investigate its heat transfer performance under real reactor axial power input. This investigation lays the foundation for the design and analysis of the heat transfer characteristics of high-temperature heat pipes.

Thermal Response of Heat Pipe with Axially Swallow-Tailed Microgrooves for the Application of Multiple Heat Sources

Thermal Analysis and Maximum Heat Transport of a Micro Flat Heat Pipe with Axial Triangle Grooves

Numerical Investigation of High-Temperature Heat Pipes with Different Wick Structures under Non-Uniform Heating Boundary Conditions

Numerical Study of the Thermal Performance of a Hydrogen Pulsating Heat Pipe

Mathematical Model and Numerical Simulation of Flow and Heat Transfer in LHP's Capillary Wick with Azimuthal Vapor Grooves

Numerical Simulation of Silicon Micro Flat Heat Pipes with Axial Triangle Grooves

Investigation on Microheat Pipe Array with Arteries

A Review of the Numerical Models for Heat and Mass Transfer in High-Temperature Heat Pipes

Fluid flow and heat transfer model for high-speed rotating heat pipes

Transient Multidimensional Analysis of Nonconventional Heat Pipes With Uniform and Nonuniform Heat Distributions

Heat Transfer Capacity Optimization Design of Microgroove and Microcolumn in an Ultra-Thin Flat Heat Pipe

Numerical Research on Heat Transfer Characteristics of Evaporation Segment of Separate Type Heat Pipe

Heat transfer with flow and evaporation in loop heat pipe’s wick at low or moderate heat fluxes

Numerical investigation on transient and steady phase change heat transfer in the evaporator of a loop heat pipe

Three-dimensional transient mathematical model to predict the heat transfer rate of a heat pipe

3D Heat Transfer Analysis in a Loop Heat Pipe Evaporator with a Fully Saturated Wick

Transient Analysis of A Cylindrical Heat Pipe Considering Different Wick Structures

Experimental and theoretical investigation of the influence of heat transfer rate on the thermal performance of a multi-channel flat heat pipe

Numerical simulation on heat and mass transfer in gravity heat pipe

Experimental investigation and analytical prediction of a multi-channel flat heat pipe thermal performance

A New Heat Transfer Model for Single U-pipe Ground Heat Exchanger