Abstract:This article proposes a digital control structure for a doubly decoupled gyroscope working in the Lissajous frequency-modulated (LFM) mode based on digital phase-locked loops (PLLs), which demodulates the angular rate signal directly from the readable digital gyroscope resonance frequency, eliminating the need for specific frequency readout circuits. The resonance frequencies of the LFM gyroscope working modes contain a mode mismatch frequency modulated by input angular rate, respectively, which are tracked by two digital PLLs followed by subsequent digital demodulation and filtering. A linearized model of the digital PLL is built to analyze noise and control characteristics for different PI parameters. The impact of different amplitude–phase extraction architectures on the extracted phase signal is also addressed in this article. Contrast experiments are carried out using the same gyroscope with large internal thermal stress due to the silicon-glass bonding process and no stress relief structure around the sensing element, working in the traditional amplitude-modulated (AM) mode and the LFM mode. Overall, the LFM working mode maintains its low-temperature sensitivity and high stability in spite of the large internal thermal stress in the gyroscope compared to AM working modes. The maximum scale factor variation over the temperature range from 10 °C to 50 °C is 1000 ppm for the LFM mode compared to 51 900 ppm for the AM closed mode. The maximum zero rate output drift over the same temperature range is 0.1248 °/s for the LFM mode and 10.7139 °/s for the AM closed mode. The scale factor nonlinearity is 329 ppm with an angular rate input range of ±50 °/s for the LFM mode compared to 1902 ppm for the AM closed mode. The LFM mode zero-bias fluctuation for ten days is less than 0.12 °/s. The angle random walk (ARW) and the bias instability (BI) of the LFM gyroscope are 0.316 °/ $\surd \text{h}$ and 2 °/h, respectively.

A novel PLL-based phase control technique in the digitalized closed-loop gyroscope interface circuit

Design of Charge Pump for High-Speed Phase-Locked Loop

A Digital Control Structure for Lissajous Frequency-Modulated Mode MEMS Gyroscope

An Improved Phase Lock Loop for Micromechanical Gyroscope with A Carrier Modulation

Multi-chip Phase Synchronization Circuit of Fractional-N PLL

Digital closed-loop controller design of a micromachined gyroscope based on auto frequency swept

An Interface ASIC for an Atmospheric-Pressure MEMS Gyroscope with PLL-Based Phase Adjustment and SC Amplitude Regulation

A Digital Closed-loop Control System for MEMS Resonant Pressure Sensors Based on A Quadrature Phase-locked Loop

A Low-Cost, Leakage-Insensitive Semi-Digital PLL with Linear Phase Detection and FIR-embedded Digital Frequency Acquisition

Digital PLL with Fixed Number of Sampling Points for Repetitive Control Algorithm

Implementation of Close-Loop Control for Interleaved CrM Totem-Pole PFC Converters with GaN Devices

Three-phase digital phase-locked loop based on synchronous reference frame

Low-Noise Low-Delay Digital Signal Processor for Resonant Micro Optic Gyro

An improved Phase/Frequency Detector and a glitch-suppression charge pump design for PLL applications

A Digital Optical Phase-Locked Loop For Diode Lasers Based On Field Programmable Gate Array

Research on a Silicon Gyroscope Interface Circuit Based on Closed-Loop Controlled Drive Loop

Design of an interface circuit system for mode-separation MEMS digital gyroscope

A Low-Power and Small Chip-Area Fractional-N Digital PLL with Combination of DPI and TDC

Double Closed-Loop Resonant Micro Optic Gyro Using Hybrid Digital Phase Modulation.

A Dividerless Pll with Low Power and Low Reference Spur by Aperture-Phase Detector and Phase-To-Analog Converter

An 8-14Ghz 180Fs-Rms DTC-Less Fractional ADPLL with ADC-Based Direct Phase Digitization in 40nm CMOS