Abstract:Laser forming has become a viable process for the shaping of metallic and non-metallic sheet components, as a means of rapid prototyping and of adjusting and aligning. In order to advance the laser forming process further for practical application in industry, the research of laser forming was performed on common stainless steel 1Cr18Ni9Ti sheet with a Nd:YAG laser source in this paper. In order to obtain convergent and highly accurate results in a reasonable time, a rezoning technique for laser heat flow density is used to adapt the mesh in the FEM simulations of low-velocity laser forming process, single pulse jump light source is applied in place of continuous scan of laser beam. It includes the empirical investigations to determine processing parameters using the temperature gradient mechanism to form different angles with simple straight line laser scanning. The simulation results of temperature field and deformation field of laser forming of metal sheets accord with the experimental results, which showed that the bending angle increases approximately linearly as the scanning times increase. And the bending angle firstly increases with the laser power increasing and begins to decrease at a certain processing parameters, as there is a certain power parameter resulting in a maximum bending angle for a certain material and parameters. The bending angle increases as the laser beam diameter increase and begins to decrease at a certain processing parameters, as a maximum bending angle is acquired when the beam diameter is the same as the thickness of the metal sheet. Bigger sheet thickness leads to smaller bending angles, and thickness is the most important influencing factor of bending angles. The bending angle increases with the sheet width, but there is a width limit bigger than which the sheet width has little influence on bending angles.

Laser Bending of Silicon Sheet: Absorption Factor and Mechanisms

Three-Dimensional Numerical Study on Temperature Field of Laser Bending of Sheet Metal

Numerical And Experimental Investigation Of Deformation Field During Laser Forming Of Metal Sheet

Real-time monitoring of temperature gradients and bending mechanism in multi-scan laser forming process

Combined Continuum-Atomistic Modeling of Ultrashort-Pulsed Laser Irradiation of Silicon

Study for Laser Controlled Fabrication of Micro/Nano-Structures of Silicon Based on Multi-Physics Model

Deformation Behaviours of Laser Curve Bending of Sheet Metals

Numerical Simulation of Stainless Steel-Carbon Steel Laminated Plate Considering Interface in Pulsed Laser Bending

Cohesive behavior of single crystalline silicon carbide scribing by nanosecond laser

Effect of temperature on the ductile-to-brittle transition in laser-assisted mechanical ruling of silicon

STUDY ON LASER BENDING OF TITANIUM ALLOYS SHEETS

Mechanical modeling of bending stiffness degradation for soft-honeycomb sandwich structure under CW laser heating

Molecular Dynamic Simulation of Non-Melt Laser Annealing Process

Influence of laser beam process parameters on the bending ability of Ti-6Al-4V titanium alloy sheets

Characterization of the deformation behavior and microstructure evolution in laser bending of TC4 titanium alloy heavy plate

Deformation analysis of laser processed grain oriented silicon steel sheet using moire interferometry

Serum gamma-glutamyltransferase as a measure of sporidesmin-induced liver damage in sheep.

Morphology evolution mechanisms and localized structural modification of repaired sites on fused silica optics processed by CO2 laser rapid ablation mitigation

Laser cutting sandwich structure glass–silicon–glass wafer with laser induced thermal–crack propagation

Multi-Physics Coupling Simulation of Picosecond Pulsed Laser Ablation of Single-Crystal Silicon

Curved Laser Bending of Titanium Alloy Sheets and Effects of Heat Radiation on Its Microstructure and Property