Abstract:The insulation condition is the key to determining whether gas insulated switchgears (GISs) can operate stably and reliably. Partial discharge (PD) detection is an important technique for condition monitoring and evaluation in GIS. Acoustic emission (AE) method is commonly used in on-site PD detection. However, in field applications, there are often problems such as low signal-to-noise ratio (SNR) of measured ultrasonic signals and difficulty in extracting PD pulses. To solve this problem, a denoising method for GIS ultrasonic signals based on the combination of ultrasonic and ultra-high frequency (UHF) signals is proposed in this paper. Based on the difference in correlation between noise and PD signals, the noise in measured signal can be suppressed through accumulating and averaging of multiple ultrasonic signals, and the SNR of PD signal can be significantly improved. An actual 500-kV GIS experiment platform is established, and PD measurements for different types of defects are conducted. Then, a comparative study is conducted on the denoising performance of the proposed method and traditional denoising methods such as wavelet method and singular value decomposition (SVD) method. The results indicate that compared to traditional methods, the method proposed in this paper has a higher reduction in noise level. Especially for extremely low-SNR signals (PD pulses buried in noise), traditional methods have poor performance, while the proposed method can still extract the PD pulse form the noise. Furthermore, based on the denoised ultrasonic signals, the defect localization analysis is conducted to demonstrates the correctness of the denoising results. Finally, the proposed method is applied to on-site PD detection, which further evaluates the effectiveness of the denoising method.

Research on test conditions of sealed-relay remainders based on high-speed video technology

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Design and Testing of an Impact Sensor Using Two Crossed Polyvinylidene Fluoride (PVDF) Films

Research and Application of a Novel Sensitivity Measurement Method for Particle Impact Noise Detection Sensors

Research on a synchronised classification method for loose particle detection signals of aerospace- sealed electronic components

Realization and Test of the Energy Directional Protection

NOISE EVALUATION BASED ADAPTIVE FAST DISTANCE RELAY PROTECTION

A High-Speed Dynamic Measurement System for Transient Space Charge in Insulation Materials

Research on Deep Defect Detection Method of Cable Lead Sealing Based on Improved Pulsed Eddy Current Excitation

A Novel Approach to Partial Discharge Detection Under Repetitive Unipolar Impulsive Voltage

A PVDF-based Perforation Damage Pattern Recognition Method for Sealed Cabin

Test of Si-PIN Strip Detector by Electronic Method

Partial Discharge Localization on Power Cables Based on a Novel Signal Relay System

Analysis and Rejection of Noises from Partial Discharge (PD) On-Site Testing Environment

Research of Labyrinth Seals Clearance Test System Based on Optical Fiber Sensor

A Pulse Interference Suppression Method Based on Double-Sensor Detection for PD Measurement in Frequency-Tuned Resonant Tests

Passive Wireless Partial Discharge Sensors with Multiple Resonances

A Denoising Method for Partial Discharge Ultrasonic Signals in GIS Based on Ultra-High Frequency Signal Synchronization

Testing and Simulation of Comb-Driven MEMS Relay by Applying Digital Image Correlation Technology

A study on the validation of a single-particle measurement system for leakage gamma-ray decay curves

Detection and Identification Technologies of Wide Band Partial Discharge