Fabrication and Characterization of Aluminum Fibers by Peripheral Milling
Yong Tang,Zhanshu He,Minqiang Pan,Zhenping Wan,Longsheng Lu,Liang Pan
DOI: https://doi.org/10.1080/10426910903496904
IF: 4.7832
2010-01-01
Materials and Manufacturing Processes
Abstract:A novel peripheral milling process with an end milling cutter for manufacturing aluminum fibers is proposed. Most of the cutting is done by the peripheral teeth of the cutter and the chips removed by the teeth form aluminum fibers, while the cutter end has little effect on aluminum fibers. The machining principle and the formation mechanism of aluminum fiber cross-section are presented. The feasibility of this new fabrication process is experimentally investigated under different machining conditions. In addition, influences of cutting parameters on the equivalent diameter, the length, and surface morphology of aluminum fibers are analyzed. Experimental results indicate that aluminum fibers can be successfully manufactured by peripheral milling and the productivity can be improved by increasing the rotational speed n. Smaller radial depth of cut a e , larger rotational speed n, and smaller feed speedv f are in favor of obtaining slim aluminum fibers. The length of aluminum fibers is theoretically determined by the axial depth of cut a p and also actually affected by other cutting parameters. Of all the cutting parameters considered in these experiments, the optimum parameters of a e , n, and v f are 0.3 mm, 118 r/min, and 60 mm/min, respectively.