Abstract:The centrifugal compressor is widely used for gas compression in various industrial fields such as aero-engine, gas turbine and turbocharger. However, the stable operating range is usually restricted by the occurrence of flow instability such as stall and surge. The paper experimentally examines the developing process of surge and stall occurring in a centrifugal compressor to advance the understanding on flow mechanism of flow instability. It is found that three types of pressure fluctuation can be observed at low flowrate region. At the critical point, the local stall firstly occurs in some specific diffuser passages and the enlarged local diffuser stall eventually induces the mild surge of compression system indicated by the sinusoidal pressure fluctuation. At lower mass flow rate, the diffuser stall cell begins to circumferentially propagate along the impeller rotating direction at 11% of rotor speed with the existence of mild surge. In comparative analysis of IGV pre-swirl angle on the occurrence of mild surge, the mild surge still occurs at the operating condition when the slope of the characteristic map of test stage is still obviously negative, in which the compression system is supposed to be stable in previous study. And a new suggested criterion for the prediction of mild surge is demonstrated that the occurrence of mild surge depends on the destabi-lization effect of downstream components about diffuser and volute. Combined with the experimental data, the streamwise distribution characteristic of diffuser stall can be used to develop the simplified model of lumped parameters for the analysis on the generation mechanism of the diffuser rotating stall. The quantitative investigation on the relation between the pressure-rise characteristic of subcomponents and the occurrence of mild surge and diffuser rotating stall not only advances the prediction of stability limit but also lays the theoretic foundation for controlling these unsteady behaviors to improve the operating range.

Effects of Stator Clocking on Unsteady Rotor Loading in a Low-Speed Centrifugal Compressor

NUMERICAL INVESTIGATION OF STATOR CLOCKING EFFECTS ON THE DOWNSTREAM STATOR IN A 1.5-STAGE AXIAL TURBINE

Effect of clocking on unsteady rotor blade loading in a low-speed axial compressor at design and off-design operating conditions

An Experimental Investigation On The Clocking Effect Between Inlet Guide Vanes And Vaned Diffuser In A Centrifugal Compressor Stage

Numerical Investigation of Compressor Rotor Blade Clocking Effects on Aerodynamic Loading of the Stator Vane

Numerical Investigation of the Effect of Stator Clocking on Blade Boundary Layer Flow in Compressor

Numerical Study of Influence of Rotor Blades' CLOCKING Effect on Aerodynamic Performance of a Multistage Compressor

Unsteady Blade Loading with Clocking in Multistage Axial Compressors, Part 1

Experimental investigation of transient characteristics of mild surge and diffuser rotating stall in a centrifugal compressor with vaned diffuser

Clocking Effect under Different Inlet Guide Vanes Prewhirl Angles in a Centrifugal Compressor

Unsteady Blade Loading with Clocking in Multistage Axial Compressors, Part 2

Experimental Study of Stator Clocking Effects in an Axial Compressor

Fully clocking effect in a two-stage compressor

An experimental investigation of the vane clocking effects on the centrifugal compressor time-averaged performance

Numerical Research on Effect of Rotor CLOCKING on Blade Security in Compressor Stages

Numerical Simulation of Rotor Clocking Effect in a Low-Speed Compressor

Effect of Rotor CLOCKING on Blade Aerodynamic Load in Compressor Stages

Clocking Effect in a Two-Stage Compressor with Different Inter-Blade-row Gaps

Effect of Unsteady Secondary Vortices on Performance of a 1.5-Stage High-Pressure Turbine

Numerical Simulation of Clocking Effect on Turbine Blade Unsteady Force

Numerical Investigation of Influence of the Clocking Effect on the Unsteady Pressure Fluctuations and Radial Forces in the Centrifugal Pump with Vaned Diffuser