Abstract:An interference-robust reconfigurable receiver in 65-nm CMOS is presented. The front end is split into a low-band (LB) RF path (0.1-1.5 GHz) and a high-band (HB) RF path (1-5 GHz). By utilizing a harmonic recombination technique, the LB path could reject the third/fifth-order harmonic interferences. A tunable narrowband dual-feedback commongate low-noise amplifier (LNA) with LC resonant load provides second-order bandpass filtering to reject the harmonic interferences in the HB path. The RF high-Q bandpass filtering based on the voltage-mode passive mixer and the current-mode low-pass filter in the analog baseband improves the receiver's resilience to out-of-band interferences. A novel power-detectionbased automatic frequency calibration technique is proposed to calibrate the operating frequency of the LNA in the HB path and overcome the effects of process, voltage, and temperature variations. The presented receiver has been implemented in a 65-nm CMOS and consumes 20-76-mW power from 1.2-V power supplies, with a core die area of 5 mm(2). The measured results show that the receiver can tolerate -5-dBm interference with 16-dB noise figure (NF) and achieve 95-105-dB maximum conversion gain and 1.7-8-dB NF over 0.1-5 GHz. It also achieves an average harmonic rejection (HR3)/HR5 of 61/68dB, +7.1/+14.4 dBm in-band/out-of-band input third-order intercept point (OB-IIP3), +71.2-dBm OB-IIP2, and 58.1-dB-image rejection, after the digitally assisted calibrations. The system-level measurements show that the presented receiver achieves 2.1% error vector magnitude (EVM) for 850-MHz Global System for Mobile Communication signals and 5% EVM for band 42 time division duplexing-local thermal equilibrium (LTE) signals, respectively.

Anti‐interference Improvement of Reconfigurable Zero‐if RF Receiver Based on Tunable Filter Array Computation

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A 0.6-V Zero-IF/Low-IF Receiver with Integrated Fractional-N Synthesizer for 2.4-Ghz ISM-Band Applications.

A Blind Calibration Model for I/Q Imbalances of Wideband Zero-IF Receivers

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

A Frequency-Domain I/Q Imbalance Calibration Algorithm for Wideband Direct Conversion Receivers Using Low-Cost Compensator.

A 1.3–1.7-Ghz $Q$ -Enhanced Resonator-Based High-IF Bandpass Filter with 1.5%–67% Tunable Fractional Bandwidth in 65-Nm CMOS Process

Design on Low-pass Filter Based on TD-SCDMA

An Eighth Order Channel Selection Filter for Low-if and Zero-if DVB Tuner Applications

Eliminating the Impacts of Flicker Noise and DC Offset in Zero-IF Architecture Pulse Compression Radars

A 1.8-V, 5-Ma Reconfigurable Analog Baseband Circuit for Low-if Multi-Mode Multi-Band Receivers

Design of RF subsystem for dynamic spectrum sharing system in UHF band

5.1 A 5-to-16ghz Reconfigurable Quadrature Receiver with 50% Duty-Cycle LO and IQ-Leakage Suppression

An Interference-Robust Reconfigurable Receiver with Automatic Frequency-Calibrated LNA in 65-Nm CMOS

Design of a Wideband Reconfigurable Transmitarrray Element Using a Novel Phase Shifter with Varactors and PIN Diodes

Optimization of Subband Reconstruction for Integrated Communication and Cancellation System

Quasi-Reflectionless Tunable Filtering Antenna for Multicarrier Transceiver

A Reconfigurable IF Receiver Supporting Intra-Band Non-Contiguous Carrier Aggregation in 65 Nm CMOS.

A 253- $\mu $ W 2.4-Ghz SAW-Less Mixer-First Uncertain-IF Receiver with Blocker Tolerant for Long-Distance Ultralow-Power IoT

Interference Management in MIMO-ISAC Systems: A Transceiver Design Approach

Millimeter-Wave Receiver With Non-Uniform Time-Approximation Filter