Abstract:The U-shaped fiber configuration represents the elementary form of micro-displacement sensing, characterized by its exceptional freedom and flexibility. The study proposes the U-shaped bent single-mode–multimode–single-mode (SMS) fiber structure that integrates the multimode interference (MMI) effect for enhanced mode dispersion and the Mach–Zönder interference (MZI) effect for spectral sensitivity improvement. The transmission spectral properties of the U-shaped SMS fiber structure with a bent radius over 1 cm are experimentally measured as the change in displacement varied within the range of 5 mm in this work. As the radius decreases, the spectrum shows redshift, which is related to the central wavelength of the peak or dips—a smaller wavelength results in a stronger redshift for the same displacement change. The average sensitivity of micro-displacement measurement within a range of 5 mm is 5.41 pm/μm, and the linearity is 99.62%. The maximum sensitivity of U-shaped SMS fiber structure is 34.46 pm/μm, with the minimum displacement change of approximately 5.804 nm. The transmission spectral properties of the U-shaped SMS fiber structure within the ranges of 50 μm, 500 μm, and 5 mm are experimentally measured in this work. This experiment observed a relatively uniform spectral drift pattern in a large range of micro-displacement sensing. The measurement range is limited by the limited spectral range of the light source and the discontinuous variation in the effective refractive index. This provides an experimental reference for further understanding the characteristics of U-shaped fiber structures and applying its application in micro-displacement sensing.

Power-compensated displacement sensing based on single mode-multimode fiber Bragg grating structure

Highly Sensitive Displacement Sensor Based on Composite Interference Established Within a Balloon-Shaped Bent Multimode Fiber Structure.

Research of a Reflective Fiber-Optic Displacement Sensor with Intensity Compensation

Research on Bandwidth-Modulated and Temperature-Independent Single Fiber Bragg Grating Displacement Sensing

Self-referenced Fiber Microbend Displacement Sensor Based on Dual-Wavelength Fiber-Bragg Gratings Interposed with a Multimode Fiber Micro Bender

A novel temperature-insensitive fiber Bragg grating sensor for displacement measurement

High sensitivity micro-displacement sensor based on fiber Bragg grating and amplification substrate

Temperature-Independent Fiber Bragg Grating Micro-Displacement Sensor

Cladding-Mode Backward-Recoupling-Based Displacement Sensor Incorporating Fiber Up Taper and Bragg Grating

Simultaneous measurement of dynamic displacement and strain in a single fiber using coarse wavelength-division multiplexing and fiber Bragg-grating filter-based sensing system

Multimode interference in single mode-multimode FBG for simultaneous measurement of strain and bending

Study of Fiber Grating Displacement Sensor

Fiber-Bragg-Grating-Based Displacement Sensors: Review of Recent Advances

Simultaneous displacement, temperature and strain sensing system based on fiber macro-bend loss and edge filter

A Novel Temperature-Independent Double Fiber Bragg Grating Strain Sensor

Displacement Sensor Based on a Small U-Shaped Single-Mode Fiber

A fiber Bragg grating displacement sensor based on wedge cavity structure

Demodulation Of A Fiber Bragg Grating Strain Sensor By A Multi-Wavelength Fiber Laser

Hetero-core fiber Bragg grating for simultaneous measurement of strain and bending based on cladding mode ratiometric detection

A Low-Cost Multimode Fiber Bragg Grating Sensor System

Spectral Characteristics and Displacement Sensing of U-Shaped Single-Mode–Multimode–Single-Mode Fiber Structure