Abstract:Superplasticizers, polyacrylate latexes and asphalt emulsions were employed to investigate the influences of chemical admixtures with different sizes on the pore structure and impermeability of hardened cement pastes. With different admixture types and contents, pore structure and impermeability of specimens cured for 28 days were tested by mercury intrusion porosimetry and alternating current impedance, respectively. Scanning electron microscopy was also used to observe the microstructure of fresh and hardened pastes. The results show that, porosity, average pore size and inkbottle pores volume in the hardened cement pastes as well as permeability presented slight decrease with the increase in the content of superplasticizers. For the specimens with low latex content, the pore size in the hardened cement paste remained unchanged, or was coarsened, and the compactness and impermeability declined; for those with high latex content, the pore size was refined and compactness and impermeability were enhanced. Both of the compactness and impermeability increased with the increase in asphalt emulsion content. At the same content, the latex Ll, having smaller particle size was more effective than latex L2 and, the anionic asphalt emulsion was more effective than cationic asphalt emulsion on improving pore structure and impermeability, respectively. It was accepted that chemical admixtures were able to improve the flowability of fresh paste by enhancing the dispersion of cement grains, further the effects were extended to affect the pore structure and impermeability of hardened one. Meanwhile, the polymer was also effective to compact the interfacial zone between phases by filling up the pore space, which would lead to more compact structure of hardened paste. For the same type of chemical admixture at low content, the pore structure and impermeability were mainly influenced by the dispersion of cement grains, while at high content, the filling effect become dominant. For different types of chemical admixtures with the same filling effect, the better dispersion of cement grains would result in finer pore structure and higher impermeability.

Influence of Hardened Paste Microstructure on Rheological Property of Cementing Slurries with High Density

Long-term Thermal Performance of Oil Well Cement Modified by Silica Flour with Different Particle Sizes in HTHP Environment

Microstructure of Hardened Complex Binder Pastes Blended with Slag

The Influence of Rheology for Different Superplasticizer on High Alumina Low Cement Castable

Critical Features of Microstructure Development of Early-Age Cement Paste Revealed by Non-Contact Electrical Resistivity Measurement

Study of the Relationship between the Strength of the hydrated Cement Paste with Flyash and its Pore structure

Nanoindentation-based study of the microstructure and degree of hydration in hardened cement paste

Morphological characteristics of hardened paste of complex binder containing high volume of slag

Effect of Particle Size Distribution on the Hydration and Compressive Strength Development of Α-Calcium Sulfate Hemihydrate Paste

Permeabilities and Mechanical Properties of Hardened Cement Pastes Modified with Sodium Laurate and Nano Silica

MICROSTRUCTURAL CHARACTERISTICS OF COMPLEX BINDER PASTE CONTAINING ACTIVE OR INERT MINERAL ADMIXTURES

Effect of particle gradation characteristics on yield stress of cemented paste backfill

The Effects of Particle Packing and Inter-particle Force on Rheological Behaviors of Binary Cement Paste

Research on Slurry Flowability and Mechanical Properties of Cemented Paste Backfill: Effects of Cement-to-Tailings Mass Ratio and Mass Concentration

Microstructural Variation of Hardened Cement-slag Pastes Leached by Soft Water

Influence of the flocculation effect on the rheological properties of cement slurry

Effects and threshold of water film thickness on multi-mineral cement paste

Influence of nano-silica agglomeration on microstructure and properties of the hardened cement-based materials

EARLY HYDRATION CHARACTERISTICS AND PASTE STRUCTURE OF COMPLEX BINDING MATERIAL CONTAINING HIGH-VOLUME STEEL SLAG

Influence of slag on microstructure of complex binder pastes

Influences Of Chemical Admixtures With Different Sizes On Pore Structure And Impermeability Of The Hardened Cement