Abstract:Steady-state cyclic voltammetry has several advantages that make it extremely useful for characterization of ultramicroelectrodes, such as rapid electrode performance assessment and size determination. However, due to the nanoscale size effect, the slight variations in geometry of the nanoelectrodes can lead to significant perturbations in its performance. In this study, electrochemical experiments and finite-element simulations using COMSOL Multiphysics software were conducted to characterize the steady-state current dependence on electrode radii, geometries and recesses. To study the above characterics, the Pt nanodisk electrodes with different sizes were fabricated using a laser-assisted wire pulling method on a P-2000 laser puller. Sluggish current responses were obtained for electrodes with a radius smaller than 80 nm in a 5 mmol/L ferrocene (Fc) CH3CN electrolyte solution containing 0.2 mol/L Tetra-n-butylammonium hexafluorophosphate (TBAPF6). The experimental results agree very well with the simulations. It was discovered that the sluggish responses are due to the kinetically limited electron transfer resulting from the slow reaction rate relative to diffusion. Moreover, a minimum, constant steady state current value was measured once the RG value (i.e., the ratio of overall electrode radius to active electrode radius) was greater than 3. However, the current increased obviously with the RG value decreased below this value due to the enhanced mass transport. In addition, the steady-state voltammetric responses of recessed nanoelectrodes were investigated. It was found that the steady-state current decreased rapidly as the recess depth increased and a classical sigmoidal shape current response was obtained recovering from a sluggish current response. The unique current responses resulted from the restriction of the diffusion of redox molecules in a deep channel to the electrode. To verify the correlation of recess depth to current response, a model was built based on two-dimensional axial symmetry and the obtained simulation results were consistent well with the experimental data. Our findings offer an understanding on the relationship between the nanoelectrode geometry and steady-state cyclic voltammetry, which can provide insight into their electrochemical behaviors.

Voltammetric Response on a Puller-Made Nanometer-Sized Electrode

The Voltammetric Response of Nanometer-Sized Carbon Electrodes

Characterization of Steady-State Current at Nanoelectrodes

The Voltammetric Responses of Nanometer-Sized Electrodes in Weakly Supported Electrolyte: A Theoretical Study

Fabrication of carbon microelectrodes with an effective radius of 1 nm

Preparation of a nanometer-sized platinum electrode and its electrochemical behavior

On the Applicability of Conventional Voltammetric Theory to Nanoscale Electrochemical Interfaces

Size-Dependent Electrochemistry of Laser-Induced Graphene Electrodes

Theory of Electrochemistry for Nanometer-Sized Disk Electrodes

Nanotextured Au Microelectrodes: Electrodeposition-based Fabrication and Their Cyclic Voltammograms Study

A 30 Nm Nanopore Electrode: Facile Fabrication and Direct Insights into the Intrinsic Feature of Single Nanoparticle Collisions.

Fabrication of Disk Ultramicroelectrode Using Nanoskiving Method.

Investigation of the Performance of Microelectrodes with Micrometer Size Structural Diameters

Laser-patterned Thin-film Electrodes: Imaging Ion Accumulation and Trapped Nanoparticles

A theoretical consideration of ion size effects on the electric double layer and voltammetry of nanometer-sized disk electrodes.

Fabrication of Single-Particle Microelectrodes and Their Electrochemical Properties.

Considerations for Dual Barrel Electrode Fabrication and Experimentation

Fabrication of Metal Nanoelectrodes by Interfacial Reactions

Renewable and Ultralong Nanoelectrochemical Sensor: Nanoskiving Fabrication and Application for Monitoring Cell Release

Electrochemistry at Nanometer-Sized Electrodes

Nanometer-Sized Electrochemical Sensors