Two-Fluid Simulation of a Three-Dimensional Spout-Fluid Bed: Flow Structures, Regimes, and Insight into the Mechanism of Particle–Particle Momentum Transfer
Junnan Zhao,Guodong Liu,Xiaolong Yin,Xiaohui Li,Zhiyong Gao,Huilin Lu
DOI: https://doi.org/10.1021/acs.iecr.1c00928
2021-01-01
Industrial & Engineering Chemistry Research
Abstract:Spout-fluid beds are widely used in the process industry due to their facilitation of an efficient contact between particles and gas. In this paper, a two-fluid model (TFM) is set up to reproduce the various flow structures encountered during spout-fluid bed operation. The effects of normal restitution model and gas-solid drag model are assessed by comparing simulation results with the experimental and discrete particle modeling (DPM) data of Link et al. [Link et al. Chem. Eng. Sci. 2005, 60, 3425-3442; Link et al. AIChE J. 2008, 54, 1189-1202.]. Simulation results show that application of an effective restitution coefficient in TFM can improve the accuracy of prediction significantly. The drag model of HKL predicts a more reasonable result than models of Huilin-Gidaspow, BVK, and Syamlal and O'Brien. Analysis on relative contributions of kinetic motion, friction, and collision to particle-particle momentum transfer parameters, namely, particle pressure and viscosity, shows that particle-particle momentum transfer in the spout and fountain regions is dominated by kinetic motion and that in the annulus region is dominated by friction. A transition region between spout and annulus regions is proposed. This region can be delineated using a single parameter of dimensionless collisional particle pressure because in this region, particle pressure is dominated by the collisional contribution. With an increasing spout-fluid ratio, the stable spout-annulus-fountain structure gradually shifts to an unstable bubble-slug structure. The effect of collision increases and extends to the entire bed. Meanwhile, the effects of kinetic motion and friction decrease. When slugs are formed, a rebound in the influence of friction is observed, accompanied by a decrease in the influence of collision.