Highly Selective Catalytic Oxidation of Glycerol by Cu-Containing Hydrotalcites

刘献锋,张方,王晓丽,丁克强,王芳,刘俊华,宋晓波,吴功德

DOI: https://doi.org/10.3969/j.issn.1001-8719.2013.03.004

2013-01-01

Abstract:A series of Cu-containing hydrotalcite catalysts (CuxMgyAlz-CHT-T) were synthesized by hydrothermal method and calcination modification under different temperatures(T). In addition, alkali metal supported M/CuxMgyAlz-CHT-T catalysts were prepared in order to increase catalytic activity. The prepared CuxMgyAlz-CHT-T and M/CuxMgyAlz-CHT-T were characterized by means of X-ray diffraction(XRD), Fourier transfer infrared spectroscopy(FT-IR), scanning electron microscopy(SEM) and N2 adsorption-desorption isotherms, and used in selective catalytic oxidation of glycerol. The effects of catalyst preparation and oxidation reaction conditions on glycerol conversion and product selectivity were investigated. The results showed that the molar ratio of Cu to Mg obviously affected the crystal structure and catalytic performance of CuxMgyAlz-CHT-T. Among the prepared CuxMgyAlz-CHT-T catalysts the Cu0.3Mg2.7Al1.0-CHT-450 possessed the highest catalytic performance for glycerol oxidation. The optimal reaction conditions with Cu0.3Mg2.7Al1.0-CHT-450 as catalyst were the reaction temperature of 60°C, n(NaOH)/n(Glycerol)=8, oxygen volume flow rate of 80 mL/min, reaction time of 10 h, under which glycerol conversion rate was 57.4%, glycelic acid selectivity reached 73.7%. The conversion rate of glycerol increased by 3.2 percent when 5%Li/Cu0.3Mg2.7Al1.0-CHT-450 was used as catalyst, compared with Cu0.3Mg2.7Al1.0-CHT-450 under the same reaction conditions. However, when the mass fraction of alkali metal supported on catalyst was excessive, the catalytic performance of the catalyst decreased, because the pores in catalyst were blocked.