Effect of accessory retention forms on the bond strength of resin-bonded fixed partial dentures: A 3D finite element study

Jingyun Han,C. Wang,YuBo Fan

DOI: https://doi.org/10.1007/978-3-642-29305-4_58

2013-01-01

Abstract:Interface debonding between prostheses and abutments was the most frequent failure mode of resin-bonded fixed partials dentures (RBFPDs) in clinic. The purpose of present study was to investigate the effect of accessory retention forms on the bond strength of RBFPDs. Three types of 3D finite element models were constructed. The model of posterior metal plate RBFPD with spoon-shaped occlusal rest seats served as control model. The remaining two type of models based on the control model added the retention form design of the pin hole and axial groove respectively. The axial or buccolingual load of 150N wad applied on the prosthesis, first premolar and first molar respectively. The maximum principal stresses of the adhesive layer in different models were calculated. Under the load of the same magnitude, the stress due to the buccolingual load was significantly higher than that due to the axial load in the adhesive layer. The proximal shoulder, occlusal rest seats wall and the proximal margin adjacent to the shoulder were the high risk region where the adhesive layer damaged easily. As compared with the control model, the pin and groove models could slightly decrease the stress in the adhesive layer after the axial loading, while the stress in the adhesive layer drastically decreased after horizontal loading and reduced by 22% and 31% respectively. These results indicate that the horizontal occlusal force has a more serious harm to the debonding of the RBFPDs. In addition, the accessory retention forms (e.g. pin and axial groove retention forms) can decrease the stress level in the adhesive layer and are conducive to increase the load-bearing capacity of RBFPDs. © 2013 Springer-Verlag.