Abstract:Partial discharge measurement plays an important role in the assessment of insulation status and fault diagnosis of power equipment. Presently, the most commonly used industrial applications of PD detections are based on the broadband measurement systems that count amplified PD pulses. The limitations of these traditional measurements are that the system requires a relatively high sampling rate and calculation capability, and is very sensitive to the ambient noise. To eliminate noise interference and save the cost of PD detection system, a technique measurement of excess currents, which measures the dielectric response currents through test object before and after PD activities to capture the activities of PD, has been reported in some recent studies. This work aims to explore the parameters that characterize the PD activities via excess current technology and to seek new ideas for PD detection. In this work, a measurement setup for measurement of PD excess currents averaged from 300 periods is applied and three typical insulation defect models were tested under 50Hz voltages. Excess currents for each case are measured. Then the corresponding dielectric loss factors and circuit impedances are obtained by comparing them to the synchronous voltages. The results show that the loss factors increase after PD while the circuit impedances decrease. Meanwhile, the loss factors continue to increase and the circuit impedances continue to decrease as the voltages turn up where the rate of the change shows more rapid in the needle-plate model. Moreover, the loss factors and circuit impedances in the dielectric barrier model and air void model are respectively higher and lower than the values before PD when the voltages drop below the PD extinction voltages, which does not appear in the needle-plate model. These characteristics provide a new idea for PD detection by monitoring the loss factors or circuit impedances via excess current detection.

Transient Earth Voltage Measurement in PD Detection of Artificial Defect Models in $\Hbox{sf}_{6}$

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Experimental Investigation of Transient Earth Voltage and Acoustic Emission Measurements of Partial Discharge Signals in Medium-Voltage Switchgears

Application of Transient Earth Voltage Method in PD Detection in GIS

Comprehensive Detection of Partial Discharge in Switchgear Using TEV

Discharge Diagnosis of Metal-enclosed Switchgear by Using TEV Method

Partial discharge detection, diagnosis, and location technology based on a novel transient earth voltage-ultrasonic integrated sensor used for switchgear equipment

Efficient and Low-Cost PD Monitoring and Locating System for MV Switchgears Using TEV Detectors

Measurement of partial discharge pattern on typical defects in GIS

Insulation Status Diagnosis On Metal-Enclosed Switchgear Via Tev Sensing Network

A Technique For Tev-Based Detection And Location Of Partial Discharges On Mv Metal-Clad Switchgears

Research on Partial Discharge Monitoring System of Switchgear Based on Wireless Distributed TEV Sensors

Simulation analysis of transient earth voltages aroused by partial discharge in switchgear

Online Monitoring of Partial Discharge in High Voltage Switchgear Using a Differential Electric Field Sensor

Study on the Partial Discharge Characteristics and Development Process in Use of the Multiple Discharge Patterns for the Typical Defects in Gas-Insulated Switchgear

Partial Discharge Detection and Analysis of Needle-Plane Defect in SF6 under Negative Oscillating Lightning Impulse Voltage Based on UHF Method

PD Detection under Impulse Voltage on an Actual SF6 Bus Section with Protrusion Defects Fixed on HV Conductor

A Method for Tracing the Partial Discharge of Switchgear Based on Distributed Transient Earth Voltage Measurement

Dielectric Loss Factor and Circuit Impedance under Partial Discharge Via Excess Current Detection

Partial Discharge Characteristics of Typical Insulation Defect under AC and Impulse Superimposed Voltage in SF6 Gas

Partial Discharge Characteristics over Sf6/Epoxy Interfaces under Impulse Voltage