Abstract:Understanding the mechanism of intermittent plastic flow in single crystal at micron to nano scale is vitally important to the fields where the reliability of system is paramount. Jumps in the stress-strain curves (strain bursts) are usually interpreted from the perspective of internal processes of material such as dislocation avalanches or intermittent activation of dislocation sources. However, the responses obtained by the sensors are also severely affected by the loading system, and this effect is often neglected in understanding the essence of strain burst. Thus, after analyzing the detailed deformation process of the loading system and the pillar during the period of strain burst, the theoretical model with the loading system that is assumed to be linearly elastic and the pillar connected in series is established. Also, the constitutive relations of micro-pillars are obtained by molecular dynamics (MD) in which the plastic flow stresses fluctuate. Based on the model, the critical condition of the instability of loading system is derived. It is shown that strain burst is the response obtained by the sensors during the period of instability of loading system caused by strain softening of the pillar and whether or not strain burst occurs depends on the degree of strain softening of pillar and the ratio of initial stiffness of the pillar to the effective stiffness of the machine. The size of strain burst is also predicted under the assumption that the strain softening stage continues to the point where elastic strain energy released by the loading system is equal to energy absorbed by the pillar and then this softening stage immediately turns into a linear elastic stage. In addition, the mechanism behind large strain burst is also revealed.

Sample Size Effects on the Large Strain Bursts in Submicron Aluminum Pillars

The Effect of Size on Dislocation Cell Formation and Strain Hardening in Aluminium

Deformation mechanism maps for sub-micron sized aluminum

Numerical Study of the Size-Dependent Deformation Morphology in Micropillar Compressions by a Dislocation-Based Crystal Plasticity Model

The Investigation of Size Effect for Dislocation Starvation Mechanism UNDER Cu Single-Crystal Micro-Pillar Compression

Strain Rate Effects on the Plastic Flow in Submicron Copper Pillars: Considering the Influence of Sample Size and Dislocation Nucleation

In Situ TEM Investigation of the Mechanical Behavior of Micronanoscaled Metal Pillars

Size Effects in Strength and Strain Hardening Behavior of Single-Crystal 7075 Aluminum Alloy Micropillars

Long-distance interface diffusion induced non-volume-conserved deformation in self-supported submicron-sized aluminum pillars

Effects of size on the mechanical response of metallic glasses investigated through in situ TEM bending and compression experiments

Nanoscale Origins of the Size Effect in the Compression Response of Single Crystal Ni-Base Superalloy Micro-Pillars

Size-dependent to Size-Independent Transition in Creep of Single Crystalline Cu Micropillars

The Influence of Nano/micro Sample Size on the Strain-Rate Sensitivity of Plastic Flow in Tungsten

SIZE EFFECT ON DEFORMATION MODE IN MICRON-SIZED Ti-5Al SINGLE CRYSTAL LOADED ALONG $[2\,\overline 1 \,\overline 1 \,0]$ AND [0001]

Interpreting Strain Burst in Micropillar Compression Through Instability of Loading System

Plate-like precipitate effects on plasticity of Al-Cu alloys at micrometer to submicrometer scales

Surface-controlled dislocation multiplication in metal micropillars

Plastic Deformation of Submicron-Sized Crystals Studied by In-Situ Kikuchi Diffraction and Dislocation Imaging

A Micropillar Compression Simulation by A Multiscale Plastic Model Based on 3-D Discrete Dislocation Dynamics

Direct quantification of mechanical responses of TiSiN/Ag multilayer coatings through uniaxial compression of micropillars

Molecular Dynamics Simulation of the Deformation of Al Nanopillars