Abstract:ATLAS LAr calorimeter will undergo its Phase-I upgrade during the long shutdown (LS2) in 2018, and a new LAr Trigger Digitizer Board (LTDB) will be designed and installed. Several commercial-off-the-shelf (COTS) multi-channel high-speed ADCs have been selected as possible backups of the radiation tolerant ADC ASICs for the LTDB. To evaluate the radiation tolerance of these backup commercial ADCs, we developed an ADC radiation tolerance characterization system, which includes the ADC boards, data acquisition (DAQ) board, signal generator, external power supplies and a host computer. The ADC board is custom designed for different ADCs, with ADC drivers and clock distribution circuits integrated on board. The Xilinx ZC706 FPGA development board is used as a DAQ board. The data from the ADC are routed to the FPGA through the FMC (FPGA Mezzanine Card) connector, de-serialized and monitored by the FPGA, and then transmitted to the host computer through the Gigabit Ethernet. A software program has been developed with Python, and all the commands are sent to the DAQ board through Gigabit Ethernet by this program. Two ADC boards have been designed for the ADC, ADS52J90 from Texas Instruments and AD9249 from Analog Devices respectively. TID tests for both ADCs have been performed at BNL, and an SEE test for the ADS52J90 has been performed at Massachusetts General Hospital (MGH). Test results have been analyzed and presented. The test results demonstrate that this test system is very versatile, and works well for the radiation tolerance characterization of commercial multi-channel high-speed ADCs for the upgrade of the ATLAS LAr calorimeter. It is applicable to other collider physics experiments where radiation tolerance is required as well.

Design of trigger test board for the Daya Bay neutrino experiment

Design of the Local Trigger Board for the Daya Bay Reactor Neutrino Experiment

The control and monitor interface of the local trigger board for the Daya Bay Neutrino Experiment

Prototype of the Digital Hardware Trigger System for TAO Central Detector

Design of Prototyping PMT Electronic System for Daya Bay Reactor Neutrino Experiment

Design and Evaluation of the LAr Trigger Digitizer Board in the ATLAS Phase-I Upgrade

A high-resolution TDC-based board for a fully digital trigger and data acquisition system in the NA62 experiment at CERN

The Clock and Control System for the ATLAS Liquid Argon Calorimeter Phase-I Upgrade

Title The detector system of the Daya Bay reactor neutrinoexperiment

Design, Characterization, and Sensitivity of the Supernova Trigger System at Daya Bay

The Trigger and Timing System of the Double Chooz Experiment

Design and implementation of a ground detection system for HERD-TRD front-end electronics

Clock Alarm Function in Trigger System of Daya Bay Reactor Neutrino Experiment

The Clock Distribution System for the ATLAS Liquid Argon Calorimeter Phase-I Upgrade Demonstrator

Development of a 100 ps TDC based on a Kintex 7 FPGA for the High Granular Neutron Time-of-Flight detector for the BM@N experiment

Design of a Time-to-Digital Converter ASIC and a mini-DAQ system for the Phase-2 upgrade of the ATLAS Monitored Drift Tube detector

Development & Implementation of the Trigger for a Short-baseline Reactor Antineutrino Experiment (SoLid)

Design and Performance of a Low-Energy Gamma-Ray Trigger System for HERD

Design and Implementation of TAO DAQ System

Themuon system of the Daya BayReactor antineutrino experiment

Development of an ADC radiation tolerance characterization system for the upgrade of the ATLAS LAr calorimeter