Abstract:In the traditional calculation model of mesh stiffness, the tooth root crack is commonly assumed to be in a closed state. However, the gear tooth crack will open under the action of mesh force in the meshing process, the mesh stiffness of the cracked tooth and the dynamic response of gear system is thus different from the closed crack case. There almost no studies have been done to investigate the influence of tooth crack open state on mesh stiffness and dynamic response. Thus, this paper presents an improved mesh stiffness calculation model of the cracked gear, in which the effective compression section and the neutral layer of the cracked tooth are re-evaluated considering the crack opening state. Then, the accuracy of the proposed model is verified by the finite element method (FEM), and the differences of mesh stiffness and statistical indicators of the dynamic response between the proposed and traditional models are further studied. The mesh stiffness calculation results show that the proposed model achieves a higher accuracy than the traditional model. And its precision gradually increases as the crack grows, which can be improved by 2.35% in the case of large crack (48.38% crack) when compared to the traditional model. The fault response signal obtained from the traditional model yields a larger amplitude than the actual situation, which will lead to errors of the statistical indicators used for fault diagnosis, in particular, the RMS value can be up to an average percentage difference of 11.98% under the large crack (48.38% crack). It is concluded that the proposed model has a higher accuracy for calculating the mesh stiffness of the cracked gear and can be further used to serve the fault diagnosis and detection of the gear system.

Crack Identification of the Sprocket Wheel in Sintering Machine Based on Wfem

Fatigue Crack Propagation Analysis in an Aero-Engine Turbine Disc Using Computational Methods and Spin Test

The application of wavelet finite element method on multiple cracks identification of gear pump gear

Numerical Simulation of Surface Acoustic Wave and Detection of Surface Crack in Steel

Study on the EMD-based transverse rotor crack detection

Assessment of Mechanical Crack Fault Dependent on Wavelet Finite Element Model

Fatigue Crack Identification Method Based on Relative Change of Strain in Engine Block

A novel method for gear crack fault diagnosis using improved analytical-FE and strain measurement

Identification of Crack in Functionally Graded Material Beams Using the P-Version of Finite Element Method

Vibration-Based Crack Identification of Generally Supported Beam Structures

Crack detection in beam structures with a novel Laplace based Wavelet Finite Element method

Shaft Crack Identification Based on Vibration and AE Signals

Crack Cause Analysis of Pulverizing Wheel in Fan Mill of 600MW Steam Turbine Unit

Investigation of tooth crack opening state on time varying meshing stiffness and dynamic response of spur gear pair

Crack Detection in an Aluminium Oxide Grinding Wheel by Impact Hammer Tests

Numerical Study of Crack Prediction and Growth in Automotive Wheel Rims

Identification of wheel surface cracks under high noise environment based on texture segmentation and combination descriptor

Research on the time-varying mesh stiffness method and dynamic analysis of cracked spur gear system considering the crack position

The Fault Diagnosis For The Screw Rotor Of The Single Screw Compressor Based On Wavelet Finite Element Method

Identification of Subsurface Mesoscale Crack in Full Ceramic Ball Bearings Based on Strain Energy Theory

VIBRATION CHARACTERISTICS ANALYSIS OF CRACKED WEDGE BEAMS USING A HIGH-ORDER FINITE ELEMENT METHOD