Abstract:In the traditional calculation model of mesh stiffness, the tooth root crack is commonly assumed to be in a closed state. However, the gear tooth crack will open under the action of mesh force in the meshing process, the mesh stiffness of the cracked tooth and the dynamic response of gear system is thus different from the closed crack case. There almost no studies have been done to investigate the influence of tooth crack open state on mesh stiffness and dynamic response. Thus, this paper presents an improved mesh stiffness calculation model of the cracked gear, in which the effective compression section and the neutral layer of the cracked tooth are re-evaluated considering the crack opening state. Then, the accuracy of the proposed model is verified by the finite element method (FEM), and the differences of mesh stiffness and statistical indicators of the dynamic response between the proposed and traditional models are further studied. The mesh stiffness calculation results show that the proposed model achieves a higher accuracy than the traditional model. And its precision gradually increases as the crack grows, which can be improved by 2.35% in the case of large crack (48.38% crack) when compared to the traditional model. The fault response signal obtained from the traditional model yields a larger amplitude than the actual situation, which will lead to errors of the statistical indicators used for fault diagnosis, in particular, the RMS value can be up to an average percentage difference of 11.98% under the large crack (48.38% crack). It is concluded that the proposed model has a higher accuracy for calculating the mesh stiffness of the cracked gear and can be further used to serve the fault diagnosis and detection of the gear system.

Assessment of Mechanical Crack Fault Dependent on Wavelet Finite Element Model

A Hybrid Modeling Method of Fatigue Crack Growth for Gas Turbine Blades under Combined High and Low Cycle Fatigue Loadings

Wear-out Evolution Analysis of Multiple-Bond-wires Power Modules Based on Thermo-Electro-mechanical FEM Simulation

An adaptive finite element method for coupled fretting wear and fatigue crack propagation simulation

Crack Growth Evaluation Based on the Extended Finite Element and Particle Filter Combined Method

A novel method for gear crack fault diagnosis using improved analytical-FE and strain measurement

An engineering model of fatigue crack growth under variable amplitude loading

Crack modeling of rotating blades with cracked hexahedral finite element method

Identification of Crack in Functionally Graded Material Beams Using the P-Version of Finite Element Method

Crack Identification of the Sprocket Wheel in Sintering Machine Based on Wfem

Hybrid fatigue crack propagation analysis using damage and fracture mechanics methods

The application of wavelet finite element method on multiple cracks identification of gear pump gear

Fatigue crack growth prediction model under variable amplitude loading conditions

Fatigue crack driving force of railway bogie frames using rigid-flexible coupled dynamics: A case for beam model

Fatigue damage evolution model of stainless-steel-cruciform-joint with weld defect using AE signal

Development of Analogy Method for Thermal-Fatigue Crack Propagation in Pressurized Cylinder by Using Permeation Diffusion-Fracture Model

Fatigue Crack Monitoring Method Based on the Lamb Wave Damage Index

Investigation of tooth crack opening state on time varying meshing stiffness and dynamic response of spur gear pair

Life Prediction of Corrosion-Fatigue Based on a New Crack Growth Rate Model with Damage and the Extended Finite Element Method

Combination Analyzing Method to Characterize Damage Variable and Three Stage Model of Fatigue Damage in Low-cycle Fatigue

Gear fatigue crack prognosis using embedded model, gear dynamic model and fracture mechanics