Abstract:Atomic layer deposition (ALD) using multiwafer batch reactors has now emerged as the manufacturing process of choice for modern microelectronics at a massive scale. Stringent process requirements of thin film deposition uniformity within wafer (WiW) and wafer–wafer (WTW) in the batch, film conformity along submicrometer wafer features, thin film quality, and the utilization of expensive precursors in the reactor dictate ALD reactor design and process parameter optimization. This paper discusses a particle-based direct-simulation Monte Carlo (DSMC) of the full reactor scale simulation that overcomes the low Knudsen number limitation of typical continuum computational fluid dynamics approaches used for modeling low-pressure ALD reactors. A representative industrial multiwafer batch reactor used for the deposition of Si-based thin films with N2 and Si2Cl6 (hexachlorodisilane) as process feed gases with pressures in the range 43–130 Pa and a uniform reactor temperature of 600 °C is simulated. The model provides detailed insights into the flow physics associated with the transport of the precursor species from the inlets, through wafer feed nozzles, into the interwafer regions, and finally through the outlet. The reactor operating conditions are shown to be in the slip/transitional flow regime for much of the reactor volume and especially the feed gas nozzle and interwafer regions (where the Knudsen number approaches ∼0.2), justifying the need for a high-Knudsen number DSMC approach as in this work. For the simulated conditions, the nonuniformity of precursor species immediately above the wafer surface is predicted to be within <1% for a given wafer and <2% across the entire multiwafer stack. Results indicate that higher pressure degrades WiW and WTW uniformity. A reactor flow efficiency is defined and found to be ∼99%, irrespective of the chamber pressure.

A Buffered Distributed Spray Mocvd Reactor Design

Hydrodynamics in a Novel Gas-Liquid Cocurrent Bubble Reactor and its CFD Simulation

Simulation-Assisted Design of Metal Organic Chemical Vapor Deposition Reactor

CFD NUMERICAL SIMULATION AND OPTIMIZATION OF GAN-MOCVD REACTOR

Operational Optimization of GaN Thin Film Growth Employing Numerical Simulation in a Showerhead MOCVD Reactor

MOCVD Process Numerical Simulation of GaN and Geometrical Optimization of the Showerhead Reactor

Modeling Of Two-Dimensional Dynamic Temperature Distribution Of A Lpcvd Process And Control Design By Mpc

Simulation of Heat Transfer in a Vertical Tubular CVD Reactor

CFD Simulation of Flow Patterns in GaN-MOCVD Reactor

Numerical Simulation of Gas Phase and Surface Reaction for Growth of GaN by MOCVD

Simulation of the ZnO-MOCVD Horizontal Reactor Geometry

Direct-simulation Monte Carlo modeling of reactor-scale gas-dynamic phenomena in a multiwafer atomic-layer deposition batch reactor

Development of a polysilicon chemical vapor deposition reactor using the computational fluid dynamics method

Numerical-simulation-based Design and Verification of MOCVD Reactor

Multi-model Simulation of 300 Mm Silicon-Nitride Thin-Film Deposition by PECVD and Experimental Verification

Manufacturing of Gallium Nitride Thin Films in a Multi-Wafer MOCVD Reactor

Operational Optimization of Polymerization Reactors with Computational Fluid Dynamics and Embedded Molecular Weight Distribution Using the Iterative Surrogate Model Method

Design and simulation of a novel MPCVD reactor with three-cylinder cavity

Simulation of temperature profile and design of heat transfer structure for reactor of film growth on Si-wafer

Numerical Study of Heating Structure in Cold-Wall MOCVD Reactor by Induction Heating

Model on Transport Phenomena and Control of Rod Growth Uniformity in Siemens CVD Reactor