Abstract:The polymorph of lithium vanadyl phosphate ε-LiVOPO4 is a promising multi-electron intercalation cathode material for Li ion batteries with theoretical capacity of 330 mAh/g. It has been shown to reversibly intercalate and deintercalate Li ions over two redox potentials corresponding to V3+/4+ and V4+/5+ oxidation states. Here we report a low-temperature (LT) hydrothermal synthesis method that produces pure LiVOPO4·2H2O between 120 and 160 oC and pure ε-LiVOPO4 between 180 and 220 oC. We also investigate the structure, electrochemical and thermal properties of the products focusing on ε-LiVOPO4. X-ray diffraction indicates that the lattice parameters of LT ε-LiVOPO4 change linearly with synthesis temperature increase, approaching those reported for high-temperature (HT) synthesized ε-LiVOPO4. Thermogravimetric analysis with mass-spectroscopy (TGA-MS) indicates water loss at 350 °C decreasing from 1.5 to 0.5 wt.% as the synthesis temperature increases from 180 to 220 °C. We have interpreted these observations as an evidence of proton intercalation into the LT ε-LiVOPO4 structure. We have further investigated the process of water loss by in-situ XRD and x-ray absorption spectroscopy (XAS) upon heating, combined with pair-distribution function analysis (PDF) and magnetic measurements of LT ε-LiVOPO4 heated to 350 and 750 °C. In-situ XRD shows abrupt change in the lattice parameters dependences upon temperature at 350 °C. Ex-situ studies indicate that the structure and properties of LT samples heated to 750 °C resemble those synthesized by the solid state method at 750 °C. Interesting reversible change of lattice symmetry upon heating to 550 °C was observed and will be further discussed. LT ε-LiVOPO4 has large particle size, over 10 μm, therefore high-energy ball-milling with carbon is required to bring the particle size to below 1 μm to achieve good electrochemistry. Ball-milled product shows high initial capacity around 300 mAh/g, which holds for about 10 cycles and then gradually decays. The voltage profile of LT ε-LiVOPO4 is sloping upon delithiation, in contrast with the step-like profile of HT ε-LiVOPO4. The detailed distinctions between LT and HT ε-LiVOPO4 leading to variations in the electrochemical performance will be discussed. This work was supported as part of the North East Center for Chemical Energy Storage (NECCES), an Energy Frontier Research Center funded by the U.S. Department of Energy, Office of Science, Basic Energy Sciences under Award # DE-SC0012583.

Deoxidization of V2o5 Powder into Vo2 Assisted by an Electrochemical Lithium Intercalation Technique

Preparation of VO2 Powder by Deoxidizing V2O5

Non-destructive Chemical Prelithiation of VO2(B) Anodes Constructing a Multifunctional Interphase Layer for Advanced Li-Ion Batteries

The Structure and Electrochemical Performance of V2O5 Powder Prepared by Hydrothermal Synthesis at Various Acidification Conditions

Low-cost Synthesis of Hierarchical V2O5 Microspheres As High-Performance Cathode for Lithium-Ion Batteries.

A clean process of preparing VO as LIBs anode materials via the reduction of V2O3 powder in a H2 atmosphere: Thermodynamic assessment, isothermal kinetic analysis, and electrochemistry performance evaluation

Facile synthesis of LiVO3 and its electrochemical behavior in rechargeable lithium batteries

High Capacity and Excellent Cyclability of Vanadium (IV) Oxide in Lithium Battery Applications

Non-destructive chemical prelithiation of VO 2 (B) anodes constructing a multifunctional interphase layer for advanced Li-Ion batteries

Vanadium Pentoxide Nanobelts and Nanorolls: from Controllable Synthesis to Investigation of Their Electrochemical Properties and Photocatalytic Activities

Preparation and Characterization of Li3v2(Po4)(3) Via Microwave Carbothermal Reduction Method

General Synthesis of Carbon-Coated Nanostructure Li4ti5o12 As A High Rate Electrode Material for Li-Ion Intercalation

Fabricating oxygen vacancy-rich Li3VO4 nanoplates to improve electrochemical performance

A liquid approach for the synthesis of M phase VO2 nanocrystals: Facile synthesis, characterization and reaction mechanism

Synthesis, Tailoring and Characterization of V2O5-Cathodes for High Performance Li+-, Na+- and Mg2+-Ion Batteries

Hydrothermal Synthesis, Structural Transformations and Electrochemistry of Lithium Vanadyl Phosphates

Synthesis of CeVO4-V2O5 nanowires by cation-exchange method for high-performance lithium-ion battery electrode

First-Principles Analysis of Li Intercalation in VO2(B)

Development of V2O3 Nanostructures for Alkali Metal Ion Batteries: A Novel Approach through Mild Metal Vapor Reduction and Interface Engineering

The Structural Evolution of V 2 O 5 Nanocystals during Electrochemical Cycling Studied Using In operando Synchrotron Techniques

Oxalic Acid-Assisted Combustion Synthesized LiVO3 Cathode Material for Lithium Ion Batteries