Abstract:Thermal bonding technology is the most commonly used approach in bonding injection-molded microfluidic chips. Although the bonding mechanism is still under debate, the molecular dynamics (MD) method can provide insight into the bonding process on a macromolecular level. In this study, MD simulations for thermal bonding of PMMA substrate and cover sheet were performed. The molecule configuration and density distribution during the thermal bonding process were studied. The effects of bonding pressure on the equivalent strain, joining energy and diffusion coefficient were investigated. The debonding process was simulated to analyze the bonding strength and failure mechanism. Simulation results show that penetration mainly takes place near the interface area. Although the final density increases slightly with increasing pressure, the bonding interface is still insufficiently filled. The equivalent strain grows faster than that in the later stage because of the gap at the interface. The bonding pressure shows clear effects on the joining energy, diffusion coefficient and stress–strain behavior. Tensile failure occurs at the interface, with PMMA chains stretched between two layers. The majority of the change in potential energy is correlated with the change in non-bonded energy. At yield strain, the low-density defect at the interface weakens the tensile strength of bonded chip.

Effect of Assistant Solvent on In-Mold Bonding of PMMA Microfluidic Chips

Research on Bonding Technology Based on PMMA Material

Thermal assisted ultrasonic bonding method for poly(methyl methacrylate) (PMMA) microfluidic devices.

Fabrication of a Three-Dimensional Microfluidic System from Poly(methyl methacrylate) (PMMA) Using an Intermiscibility Vacuum Bonding Technique

A Low Temperature Ultrasonic Bonding Method for PMMA Microfluidic Chips

Microwave Induced Ethanol Bath Bonding for PMMA Microfluidic Device

Plasticizer-assisted bonding of poly(methyl methacrylate) microfluidic chips at low temperature.

Molecular Dynamics Simulation on the Effect of Bonding Pressure on Thermal Bonding of Polymer Microfluidic Chip.

A microfluidic chip microwave bonding method based on the PMMA

The Effect of Injection Molding PMMA Microfluidic Chips Thickness Uniformity on the Thermal Bonding Ratio of Chips

Solvent Bonding of Poly(methyl Methacrylate) Microfluidic Chip Using Phase‐changing Agar Hydrogel As a Sacrificial Layer

Deformation and Strength Mechanism of Microchannels in Thin-Film Assisted Bonding Microfluidic Chips

Organic Solvent Fumigation Bonding for Multi-Layer Poly(methyl Methacrylate) Microfluidic Device

Study of PMMA Thermal Bonding

Ultrasonic Bonding for Thermoplastic Microfluidic Devices Without Energy Director

Miscible Organic Solvents Soak Bonding Method Use in a PMMA Multilayer Microfluidic Device.

A Method of Water Pretreatment to Improve the Thermal Bonding Rate of PMMA Microfluidic Chip

Photolamination Bonding for Pmma Microfluidic Chips

Fabrication of Fluidic Chips with 1-D Nanochannels on PMMA Substrates by Photoresist-Free UV-lithography and UV-assisted Low-Temperature Bonding

Plasma Assisted Thermal Bonding for PMMA Microfluidic Chips with Integrated Metal Microelectrodes

Investigation of Thermal Bonding on PMMA Capillary Electrophoresis Chip