Abstract:This study focuses on understanding the impact of different material compositions and printing parameters on the structural integrity of hybrid curved composite beams. Using the continuous filament fabrication technique, which is an advanced fused deposition modelling process, composite curved beams made of short carbon and various continuous fibre-reinforced nylon laminae were fabricated and subjected to four-point bending tests to assess their delamination characteristics. The results show that the presence of five flat zones in the curved region of a curved beam achieves 10% and 6% increases in maximum load and delamination strength, respectively, against a smooth curved region. The delamination response of a curved composite beam design consisting of unidirectional carbon/nylon laminae is superior to that of a curved beam made of glass fibre/nylon laminae, while the existence of highly strengthened glass fibre bundles is alternatively quite competitive. Doubling the number of continuous fibre-reinforced laminae results in an increase of up to 36% in strength by achieving a total increase in the beam thickness of 50%, although increases in mass and material cost are serious concerns. The hybrid curved beam design has a decrease in the maximum load and the strength by 11% and 13%, respectively, when compared with a non-hybrid design, which consists of some type of stronger and stiffer nylon laminae instead of short carbon fibre-reinforced conventional nylon laminae. Two-dimensional surface-based cohesive finite element models, which have a good agreement with experimental results, were also established for searching for the availability of useful virtual testing. The results from this study will greatly contribute to the design and numerical modelling of additively manufactured hybrid composite curved beams, brackets, and fittings.

Experimental Investigation on Deformation and Strength of Carbon/epoxy Laminated Curved Beams

Investigation on Flexural Performance of RC Beams Flexurally Strengthened by Side-bonded CFRP Laminates

Experimental investigation on shear behavior of full-scale glued laminated bamboo beams under three-point loading test and using digital image correlation technique

Investigation on the Compressive Mechanical Properties of Ultra-Thick CFRP Laminates

Dynamic Behavior of CFRP-Strengthened Reinforced Concrete Beams Without Stirrups under Impact Loading

EXPERIMENTAL STUDY OF CONCRETE BEAMS STRENGTHENED WITH CARBON FIBER SHEET USING DIGITAL SPECKLE CORRELATION METHOD

Experimental Investigation of the Effect of CNT Addition on the Strength of CFRP Curved Composite Beams

Behavior of Preloaded RC Beams Strengthened with CFRP Laminates

Predicting deflection of retrofitted reinforced concrete beams

Experimental investigation of CNT effect on curved beam strength and interlaminar fracture toughness of CFRP laminates

Investigation of Delamination Characteristics in 3D-Printed Hybrid Curved Composite Beams

Mechanical properties and damage analysis of C/C–SiC curved beam under four-point bending: Experimental and numerical investigation

Modeling on the Effect of Automated Fiber Placement Induced Gaps in Curved Composite Laminates

Experimental and numerical investigation on residual stress and deformation of welded I-section curved steel beams

Experimental and Numerical Investigation of Stiffened Composite Curved Panel under Shear and In-Plane Bending

CFRP Strengthened RC Beams with Pre-Strengthening Non-Uniform Reinforcement Corrosion Subjected to Post-Strengthening Wetting/drying Cycles

Delamination Analysis of Carbon Fiber/Epoxy Composite Laminates under Different Loading Rates Using Acoustic Emission

Flexural performance test of carbon fiber reinforced composite sandwich beams with cedarwood core

Investigation of Bending Performance of Printed Continuous Carbon Fiber Reinforced Polylactic Acid Using Acoustic Emission

Progressive failure simulation of angled composite beams subject to flexural loading

Experimental research on flexural fatigue behavior of GFRP-Balsa sandwich beams