Abstract:The emergence of additive manufacturing (AM) technologies, such as fused deposition modeling (FDM), have enabled the realization of structures with superior mechanical performance through lightweighting and multi-material architectures. However, the complexity associated with the internal geometric features and potential material configurations have also presented new challenges in designing these structures to optimize mechanical performance. In particular, the failure mechanisms and their relationship to the load bearing capacity of the structures may vary compared to analogous structures designed using conventional manufacturing techniques. In this work, we investigate failure modes of 3 D-printed (3DP) multi-material polymer sandwich beam structures manufactured from acrylonitrile butadiene styrene (ABS) and polycarbonate (PC) materials and subjected to three-point bend loading. Digital Image Correlation (DIC) is utilized to understand the effects of different process parameters on the mechanical response of the 3DP structures. ABS and PC dogbone tensile specimens were printed to establish the baseline properties in tension with varying raster angles and infill patterns. Multi-material sandwich beam structures were then printed with honeycomb cores using different processing and architectural parameters, and the failure modes and loads of these structures were compared with predications from a failure model for sandwich structures that accounts for the following conventional failure modes: (1) indentation, (2) face sheet bending, (3) core bending, and (4) core shear. With minor changes in the processing and geometric parameters, failure modes could be shifted from the face sheets to core bending and core shear, as evidenced by the DIC strain field measurements, and the corresponding max load-to-weight ratios could be increased. Estimations of the tensile properties of the face sheets and core were found to be sufficiently accurate when combining classical lamination theory (CLT) and rule-of-mixtures (ROM) models, while the failure model also predicted the load bearing capacity and failure mode in three-point bending with reasonable accuracy.

A pr 2 00 6 Universal decoherence induced by an environmental quantum phase transition

Frequent and long-term absence as a risk factor for work disability and job termination among employees in the private sector

Progressive failure simulation of angled composite beams subject to flexural loading

Experimental and Theoretical Studies on 3D Printed Short and Continuous Carbon Fiber Hybrid Reinforced Composites

Nonlinear Fracture Analysis of Delamination Crack Jumps in Laminated Composites

Investigation on the mechanical properties of 3D printed hybrid continuous fiber-filled composite considering influence of interfaces

Experimental Investigation on Deformation and Strength of Carbon/epoxy Laminated Curved Beams

Modeling on the Effect of Automated Fiber Placement Induced Gaps in Curved Composite Laminates

Investigation of bending properties of continuous fiber reinforced resin T-beams made by 3D printing

Experimental Investigation of the Effect of CNT Addition on the Strength of CFRP Curved Composite Beams

Investigation of Bending Performance of Printed Continuous Carbon Fiber Reinforced Polylactic Acid Using Acoustic Emission

Experimental and Numerical Investigation of the Mechanical Properties of 3D-Printed Hybrid and Non-Hybrid Composites

Flexural failure properties of fiber-reinforced hybrid laminated beam subject to three-point bending

A Comparative Study on Interlaminar Properties of L-shaped Two-Dimensional (2D) and Three-Dimensional (3D) Woven Composites

Fabrication and Bending Behavior of Thermoplastic Composite Curved Corrugated Sandwich Beam with Interface Enhancement

Bending Damage of 3D Printing T-beam

Predicting failure modes of 3D-printed multi-material polymer sandwich structures from process parameters

Sensor-Enhanced Thick Laminated Composite Beams: Manufacturing, Testing, and Numerical Analysis

Performance-driven 3D printing of continuous curved fibre reinforced polymer composites a preliminary numerical study

Application of a delamination model to laminated composite structures

Behavior of functionally graded carbon nanotube reinforced composite sandwich beams with pultruded GFRP core under bending effect