Abstract:The dynamic modulus (|Em*|) of asphalt mixtures is one of most fundamental mechanical parameters used in flexible pavement design, which has been extensively estimated through various predictive models. However, most of existing dynamic modulus predictive models does not fit well for the purpose of the Level 3 (the lowest input level) flexible pavement design in the current AASHTOWare Pavement ME Design due to the following major deficiencies: (1) lacking physical significance; (2) providing poor prediction accuracy; and (3) requiring laboratory testing to obtain key model parameters. To address these deficiencies, this paper is aimed to develop a new model on the basis of the law of mixtures. First, a large database is collected and revised for the new model development. Two exiting law of mixture models are then evaluated in terms of the mode prediction accuracy, and neither of them provided satisfactory prediction results. A new model is subsequently developed, which involves using a parallel form to represent the contribution of each of three phases (asphalt, aggregate and air void) to the |Em*| as well as utilizing a standard sigmoid function to characterize the mechanical response of asphalt mixture. Statistical analysis shows that the new model has comparable prediction performance with traditional Witczak models, but with significantly lower number of input variables and relatively higher model quality. Supplemental data collected from laboratory tests and independent literature sources finally validate that the new model has the capability to provide an accurate prediction of |Em*| with an R2 value up to 0.90. In these regards, the new model is believed to be a good candidate for the |Em*| prediction of asphalt mixtures for a reliable Level-3 flexible pavement design.

Predicting the Dynamic Behavior of Asphalt Concrete Using Three-Dimensional Discrete Element Method

Three-Dimensional Discrete Element Modelling Of Influence Factors Of Indirect Tensile Strength Of Asphalt Mixtures

A Dynamic FEM-DEM Multiscale Modeling Approach for Concrete Structures

Mechanical Response of Asphalt Surfaces under Moving Traffic Loads Using 3D Discrete Element Method

Prediction of Dynamic Shear Modulus of Fine Aggregate Matrix Using Discrete Element Method and Modified Hirsch Model

Micromechanical Analysis of Asphalt-Mixture Shear Strength Using the Three-Dimensional Discrete Element Method

Discrete Element Modeling of Asphalt Concrete Cracking Using a User-Defined Three-Dimensional Micromechanical Approach

Micromechanical Discrete Element Modeling of Asphalt Mixture Shear Fatigue Performance

Discrete element modelling of mechanical response of crumb rubber-modified asphalt pavements under traffic loads

A Comparison of Two-Dimensional and Three-Dimensional Micromechanical Discrete Element Modeling of the Splitting Tests for Asphalt Mixtures

Comparative Study of 2D and 3D Micromechanical Discrete Element Modeling of Indirect Tensile Tests for Asphalt Mixtures

Discrete Element Modeling of Aggregate Gradation Influence on the High Temperature Stability of Structural-Layer Asphalt Mixtures

A New Dynamic Modulus Predictive Model for Asphalt Mixtures Based on the Law of Mixtures

Simulation of Fracture Process of Asphalt Mixture Using Three-Dimension Discrete Element Method

Three-Dimensional Discrete Element Modeling of Crack Development in Epoxy Asphalt Concrete

Prediction on Dynamic Modulus of Asphalt Concrete with Random Aggregate Modeling Methods and Virtual Physics Engine

Three-Dimensional Fracture Modeling of Epoxy Asphalt Concrete Using a Heterogeneous Cohesive Softening Discrete Element Model

Micromechanical and microstructure analysis of asphalt concrete under triaxial load condition based on Discrete Element Method

Discrete Element Modelling and Experimental Study on Dilation Behaviour of Asphalt Mixtures

A Micromechanical Based Three-Dimensional DEM Approach to Characterize the Complex Modulus of Asphalt Mixtures

Prediction of Viscoelastic Behavior in Asphalt Concrete Using the Fast Multipole Boundary Element Method