Abstract:Direct contact condensation (DCC) is a phenomenon observed when steam interacts with subcooled water, exhibiting higher heat and mass transfer rates compared to wall condensation. It has garnered significant interest across industries such as nuclear, chemical, and power due to its advantageous characteristics. In the context of pressure-relief tanks, understanding and optimizing the DCC process are critical for safety and efficiency. The efficiency of pressure-relief tanks depends on the amount of steam condensed per unit of time, which directly affects their operational parameters and design. This study focuses on investigating the direct gas–liquid contact condensation process in pressure-relief tanks using computational fluid dynamics (CFD). Through experimental validation and a sensitivity analysis, the study provides insights into the influence of inlet steam parameters and basin temperature on the steam plume characteristics. Furthermore, steady-state and transient calculation models are developed to simulate the behaviour of the pressure-relief tank, providing valuable data for safety analysis and design optimization. There is a relatively high-pressure area in the upper part of the bubble hole of the pressure-relief tube, and the value increases as it is closer to the holes. The steam velocity in the bubbling hole near the 90° elbow position is higher. This study contributes to the understanding of steam condensation dynamics in pressure-relief tanks. When the steam emission and pressure are fixed, the equilibrium temperature increases linearly as the initial temperature increases (where a = 1, b = 20 in y = a x+ b correlation), the equilibrium pressure increases nearly exponentially, and the equilibrium gas volume decreases. When the steam emission and initial temperature are fixed, the equilibrium temperature does not change as the steam discharge pressure increases. The correlations between the predicted equilibrium parameters and the inlet steam parameters and tank temperature provide valuable insights for optimizing a pressure-relief tank design and improving the operational safety in diverse industrial contexts.

Theoretical Investigations On Water Condensation In Main Steam Pipe

Analysis of wave influence on steam condensation with non-condensable gases using cfd

Improved CFD simulation of water hammer caused by condensation with an enhanced phase change model

Experimental investigation on steam condensation characteristics in horizontal heat transfer pipe of PRS for HPR1000

Experimental investigation on two-phase flow instability induced by direct contact condensation in open natural circulation

Experimental Research On Steam Condensation On Cold Surface: Facility Design

The effect of the inlet steam superheat degree on the non-equilibrium condensation in steam turbine cascade

Experimental investigation of the effect of geometrical and operating variables on condensation induced water hammer in horizontally oriented pipes

Experimental investigation on the effect of direct contact condensation regime on thermal stratification

Analysis Of Effects Of Buoyancy Force On Steam Condensation With Non-Condensable Gases In A Rectangular Channel

Performance of non-equilibrium condensation flow in wet steam zone of steam turbine based on modified model

Online hydraulic calculation and operation optimization of industrial steam heating networks considering heat dissipation in pipes

Numerical investigations on the component separation phenomenon and transport behavior of steam-air-hydrogen mixture induced by condensation

Study of Condensation during Direct Contact between Steam and Water in Pressure-Relief Tank

Steam Temperature Characteristics in Boiler Water Wall Tubes Based on Furnace CFD and Hydrodynamic Coupling Model

Improvement of Condensation Model With the Presence of Non-Condensable Gas for Thermal-Hydraulic Analysis in Containment

Simulation of Coupled Hydraulic–Thermal Characteristics for Energy-Saving Control of Steam Heating Pipeline

Inversion of the Third Boundary Condition on the Inner Wall of a Two-dimensional Pipe Based on Inverse Heat Conduction Problems

Research on fluid flow and heat transfer characteristics in a three-dimensional condenser

Simulation study on transport characteristics of leakage gas from the condenser of power plant

Experimental study on heat transfer characteristics of steam underwater direct-contact condensation