Abstract:In a new pressurized water reactor nuclear power plant, the heat exchange tube bundle of the Moisture Separator Reheater (MSR) is a new designed staggered arrangement low helically finned-tube bundle. To investigation the thermal hydraulic characteristics of the Reheater part of MSR, the tube bundle test section was designed by using prototype tube and prototype arrangement of the new designed MSR. The experiment was carried out on the test section with steam cross-flowing outside the horizontal tube bundle, same conditions as MSR’ operation designing , and electrical heating in the tubes simulating the condensation heat release of the two phase-flow inside. A lot of experimental data on heat transfer and pressure drop were obtained in a broad experiment parameters range of wall heat flux density and steam temperature, pressure and Reynolds number. Based on the present data, empirical average heat transfer correlation and friction factor correlation were proposed for the outside average heat transfer and pressure drop. Comparisons and analysis between these experimental results and some of other investigations were made. The conclusions of this experimental investigation were given. The results are very useful to the design of the heat exchange tube bundle in the MSR, and the validations of the new design. However, experimental studies cannot adequately reveal the detail of flow characteristics, and suitable correlations for this fin geometry are very rare. Thus, numerical simulations should be performed to make up for the deficiency. To perform a detail understanding of the heat transfer and pressure drop characteristics, a three-dimensional geometry was carefully constructed and a fine mesh was generated. The flow across the tubes was assumed to be a steady, incompressible turbulent flow. RNG based – k turbulence model was chosen in the simulation. Nusselt number and Euler number of a wide range of Reynolds numbers (based on the steam velocity through the minimum flow area) from 4 1 10 to 4 8 10 were calculated by the CFD software ANSYS Fluent. The numerical results were compared with experiment results of the same fin geometry and tube configuration. Also, local flow behavior and local temperature distribution were obtained to show the detail flow features and heat transfer. The velocity and temperature distribution near the fin surface were discussed

Experimental investigation on steam condensation characteristics in horizontal heat transfer pipe of PRS for HPR1000

Steam Condensation on a Downward-Facing Plate in Presence of Air

Experimental Investigation on Heat Transfer Model for Secondary Side of Scaled C-shape Bundle Used in PRHR HX of AP1000

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Numerical Investigation on Heat Removal Capacity of Passive Residual Heat Removal Heat Exchanger

Investigations on water condensation in the main steam pipe of a pressurized water reactor nuclear power station: Part II—Theoretical studies

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

CFD Investigation on Thermal Hydraulics of the Passive Residual Heat Removal Heat Exchanger (PRHR HX)

Experimental study on heat transfer limit of high temperature potassium heat pipe for advanced reactors

CFD investigation on start-up transient of HPR1000 secondary side passive residual heat removal heat exchanger

Experimental evaluation on heat transfer limits of sodium heat pipe with screen mesh for nuclear reactor system

Investigations on Water Condensation in the Main Steam Pipe of a Pressurized Water Reactor Nuclear Power Station: Part I – Experimental Tests

Experimental Study on Condensation of High-Pressure Steam in A Horizontal Tube with Pool Boiling Outside

Transient analysis and optimization of passive residual heat removal heat exchanger in advanced nuclear power plant

Investigation on Heat Transfer and Flow of a Sonic Steam Jet Condensation in Crossflow of Water in Pipes

Experimental Investigation on Heat Transfer Performance of C-shape Tube Immerged in a Water Pool

Experimental Investigation on the Heat Transfer Performance of High-Temperature Potassium Heat Pipe for Nuclear Reactor

Experimental and numerical investigation of heat transfer and pressure drop in staggered arrangement helically finned-tube bundle

Numerical Study on Transient Characteristics of Passive Residual Heat Removal System

Thermal Hydraulic Analysis of a Passive Residual Heat Removal System for an Integral Pressurized Water Reactor

Research on Heat Transfer Characteristic of PRHR HX at Initial Operating Stage