Design and analysis of a 2-degree-of-freedom flexure-based micro-motion stage
Yunsong Du,Tiemin Li,Yao Jiang,Haitong Wang
DOI: https://doi.org/10.1177/1687814016638301
IF: 2.1
2016-01-01
Advances in Mechanical Engineering
Abstract:This article presents the mechanical design, dimensional optimization, finite element analysis, and experimentation of a 2-degree-of-freedom flexure-based micro-motion stage. The stage is composed of four parallel limbs with symmetrical configuration, and each limb is composed of two serially connected prismatic joints. The divided parts of flexure hinge thickness constituting the two prismatic joints are selected as two. Based on analytical models established in stiffness and dynamic analysis, the dimensional optimization is carried out to maximize the first resonance frequency. Finite element analysis is then adapted to verify the stiffness, workspace, and dynamic behavior. Finally, a prototype of the stage is manufactured and an experimental platform is set up. The experimental results show that the stage has a workspace range of 19.53 mu m x 19.07 mu m with a frequency of 1987Hz, and the cross-coupling ratio between two axes is less than 1%. For high-frequency cooperative tracking experiments, a proportional-integral controller is implemented to compensate for the tracking errors. Finally, good tracking performance at high frequency is obtained, which validates the effectiveness of the micro-motion stage.