Abstract:This paper presents a novel decoupled two degrees of freedom (2-DOF) translational parallel micro-positioning stage. The stage consists of a monolithic compliant mechanism driven by two piezoelectric actuators. The end-effector of the stage is connected to the base by four independent kinematic limbs. Two types of compound flexure module are serially connected to provide 2-DOF for each limb. The compound flexure modules and mirror symmetric distribution of the four limbs significantly reduce the input and output cross couplings and the parasitic motions. Based on the stiffness matrix method, static and dynamic models are constructed and optimal design is performed under certain constraints. The finite element analysis results are then given to validate the design model and a prototype of the XY stage is fabricated for performance tests. Open-loop tests show that maximum static and dynamic cross couplings between the two linear motions are below 0.5% and -45 dB, which are low enough to utilize the single-input-single-out control strategies. Finally, according to the identified dynamic model, an inversion-based feedforward controller in conjunction with a proportional-integral-derivative controller is applied to compensate for the nonlinearities and uncertainties. The experimental results show that good positioning and tracking performances are achieved, which verifies the effectiveness of the proposed mechanism and controller design. The resonant frequencies of the loaded stage at 2 kg and 5 kg are 105 Hz and 68 Hz, respectively. Therefore, the performance of the stage is reasonably good in term of a 200 N load capacity.

Design and Analysis of a New Flexure-Based XY Micropositioning Stage with Decoupled Motion Characteristic

Design And Analysis Of Two Dimensional X-Y Micropositioning Stage

A Decoupled 2-Dof Flexure-Based Micropositioning Stage with Large Travel Ranges

Development of a Flexure-Based XY Positioning Stage for Micro/nano Manipulation

Design and analysis of a 2-degree-of-freedom flexure-based micro-motion stage

Design and Analysis of a New Flexure-Based XY Stage

A piezodriven three dimensional micropositioning stage for nano-manufacturing

A Flexure-Based Kinematically Decoupled Micropositioning Stage with a Centimeter Range Dedicated to Micro/Nano Manufacturing

Design of a Flexure-Based Parallel XY Micropositioning Stage with Millimeter Workspace and High Bandwidth

Design, Analysis and Testing of a Novel Decoupled 2-DOF Flexure-Based Micropositioning Stage

Design And Analysis Of A Novel Xy Micro-Positioning Stage Used Corrugated Flexure Beams

Design and control of a decoupled two degree of freedom translational parallel micro-positioning stage

Dynamic Analysis of a Flexure-Based Compliant Stage

A Flexure-Based and Motion-Decoupled XYZ Nano-Positioning Stage with a Quasi-Symmetric Structure

Design and Testing of A 2-Dof Flexure-Based Compliant Stage

A Decoupled Flexure-Based Rotary Micropositioning Stage with Compact Size

A Novel Flexure-Based 3-DOF Micro-Parallel Manipulator with a Gripper for Micro/nano Manipulation

Development of a Large-Range XY-Compliant Micropositioning Stage with Laser-Based Sensing and Active Disturbance Rejection Control

Modeling And Testing Of A Novel Decoupled Xy Nano-Positioning Stage

Design and analysis of a 3-DOF planar micromanipulation stage with large rotational displacement for micromanipulation system

Design and Analysis of a 3-DOF Damped Flexure-Guided Nanopositioning Stage