Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

Design of the front-end electronics for linear position-sensitive 3 He neutron detector

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

Development of 3He LPSDs and read-out system for the SANS spectrometer at CPHS

Study of Readout System for 3he Linear Position Sensitive Detectors

An 8-channel low power ASIC for Helium-3 tube position sensitive neutron detectors

Developments of a 2D position sensitive neutron detector

Low Event Rate Neutron Detector Array Using the Coincidence Between Plastic Scintillator and Helium-3 Proportional Counters

The design of 1MCPS CMOS analog front-end circuit for radiation detector

Development of a 3-D Position Sensitive Neutron Detector Based on Organic Scintillators with Double Side SiPM Readout

Construction of a two-dimensional thermal neutron detector

A multiplex readout method for position sensitive boron coated straw neutron detector

Development and performance evaluation of a multi-layer boron-lined detector for the CPHS-SANS instrument

Front-End Design for SiPM-Based Monolithic Neutron Double Scatter Imagers

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

Design of the Thermal Neutron Detection System for CJPL-II

Low Background Thermal Neutron Detector System

High precision proton beam monitor system concept design on CSNS based on SiC

A Conceptual Design of the Readout System for a Neutrino Experiment at SNS

Design of a compact and portable space neutron spectrometer based on Monte Carlo

A novel energy resolved neutron imaging detector based on TPX3Cam for the CSNS

Design and Test Results of a Front-End ASIC for Radiation Detectors