Abstract:This paper presents a novel decoupled two degrees of freedom (2-DOF) translational parallel micro-positioning stage. The stage consists of a monolithic compliant mechanism driven by two piezoelectric actuators. The end-effector of the stage is connected to the base by four independent kinematic limbs. Two types of compound flexure module are serially connected to provide 2-DOF for each limb. The compound flexure modules and mirror symmetric distribution of the four limbs significantly reduce the input and output cross couplings and the parasitic motions. Based on the stiffness matrix method, static and dynamic models are constructed and optimal design is performed under certain constraints. The finite element analysis results are then given to validate the design model and a prototype of the XY stage is fabricated for performance tests. Open-loop tests show that maximum static and dynamic cross couplings between the two linear motions are below 0.5% and -45 dB, which are low enough to utilize the single-input-single-out control strategies. Finally, according to the identified dynamic model, an inversion-based feedforward controller in conjunction with a proportional-integral-derivative controller is applied to compensate for the nonlinearities and uncertainties. The experimental results show that good positioning and tracking performances are achieved, which verifies the effectiveness of the proposed mechanism and controller design. The resonant frequencies of the loaded stage at 2 kg and 5 kg are 105 Hz and 68 Hz, respectively. Therefore, the performance of the stage is reasonably good in term of a 200 N load capacity.

Model Based Control of Micro-Positioning Stages

Control of Multi-Dimensional Micro-Positioning Stages

Robust Control of Micro-Positioning Stage with Piezoceramic Actuator

Motion Control of Piezoelectric Positioning Stages: Modeling, Controller Design, and Experimental Evaluation

Modeling and Control of a Piezo-Driven XYZ Series-Type Compliant Nanopositioning Stage

A Compound Control Based on the Piezo-Actuated Stage with Bouc–Wen Model

Design, Control and Application of a PZT-driven Micro-stage

Design of Implementable Adaptive Control for Micro/Nano Positioning System Driven by Piezoelectric Actuator

Model Reference Adaptive Control with Perturbation Estimation for a Micropositioning System.

A Novel Hybrid Actuation Mechanism Based XY Nanopositioning Stage with Totally Decoupled Kinematics

Modeling and Control of a Novel X-Y Parallel Piezoelectric-Actuator Driven Nanopositioner

Design, modeling, and control of a monolithic compliant x-y- microstage using a double-rocker mechanism

Robust adaptive control of piezo-actuated positioning stages with an ellipse-based hysteresis model

Design, Identification, and Control of Piezoactuated Positioning Mechanism Based on Adaptive Inverse Method

Control system design for nano-positioning using piezoelectric actuators

Adaptive Robust Precision Motion Control of a Piezoelectric Positioning Stage

Design issues in a decoupled XY stage: Static and dynamics modeling, hysteresis compensation, and tracking control

Feedback linearization and equivalent-disturbance compensation control strategy for piezoelectric stage

Design and control of a decoupled two degree of freedom translational parallel micro-positioning stage

Sliding Mode Tracking Control with Perturbation Estimation for Hysteresis Nonlinearity of Piezo-Actuated Stages

Modeling and Control of Piezo-Actuated Nanopositioning Stages: A Survey