Abstract:This paper presents a novel decoupled two degrees of freedom (2-DOF) translational parallel micro-positioning stage. The stage consists of a monolithic compliant mechanism driven by two piezoelectric actuators. The end-effector of the stage is connected to the base by four independent kinematic limbs. Two types of compound flexure module are serially connected to provide 2-DOF for each limb. The compound flexure modules and mirror symmetric distribution of the four limbs significantly reduce the input and output cross couplings and the parasitic motions. Based on the stiffness matrix method, static and dynamic models are constructed and optimal design is performed under certain constraints. The finite element analysis results are then given to validate the design model and a prototype of the XY stage is fabricated for performance tests. Open-loop tests show that maximum static and dynamic cross couplings between the two linear motions are below 0.5% and -45 dB, which are low enough to utilize the single-input-single-out control strategies. Finally, according to the identified dynamic model, an inversion-based feedforward controller in conjunction with a proportional-integral-derivative controller is applied to compensate for the nonlinearities and uncertainties. The experimental results show that good positioning and tracking performances are achieved, which verifies the effectiveness of the proposed mechanism and controller design. The resonant frequencies of the loaded stage at 2 kg and 5 kg are 105 Hz and 68 Hz, respectively. Therefore, the performance of the stage is reasonably good in term of a 200 N load capacity.

Design, modeling, and control of a monolithic compliant x-y- microstage using a double-rocker mechanism

Design And Analysis Of Two Dimensional X-Y Micropositioning Stage

A Novel Piezoelectrically Actuated 2-Dof Compliant Micro/Nano-Positioning Stage with Multi-Level Amplification

Design and Analysis of a Two-Degrees-of-freedom Monolithic Compliant Piezoelectric Microgripper

Design, modeling, analysis and testing of a novel piezo-actuated XY compliant mechanism for large workspace nano-positioning

A Novel Hybrid Actuation Mechanism Based XY Nanopositioning Stage with Totally Decoupled Kinematics

Design, modeling, and analysis of a new XYθ piezoelectric microstage featuring high amplification ratios and multiple actuation modes

Design and Analysis of a New Flexure-Based XY Stage

Design and Kinematic Modeling of A Planar Piezo-Actuated Multistage Compliant Mechanism

Design and Analysis of XY Large Travel Micro Stage Based on Secondary Symmetric Lever Amplification.

Modeling and Control of a Piezo-Driven XYZ Series-Type Compliant Nanopositioning Stage

Design and control of a decoupled two degree of freedom translational parallel micro-positioning stage

Design of a decoupled 2-DOF translational parallel micro-positioning stage

Design, Control and Application of a PZT-driven Micro-stage

Design, Analysis and Testing of a Novel Decoupled 2-DOF Flexure-Based Micropositioning Stage

Model Based Control of Micro-Positioning Stages

A Kinetostatic and Dynamic Modeling Method of Piezo-Actuated Compliant Mechanisms Based on Dynamic Stiffness Matrix Method

Development of a Large-Range XY-Compliant Micropositioning Stage with Laser-Based Sensing and Active Disturbance Rejection Control

A Piezo-Driven Compliant Nanopositioning Stage with Large Stroke for Micro/Nano Manipulation

Design and Disturbance Rejection Control of a Piezoelectric Nanopositioning Stage

A Piezo-Driven 2-Dof Compliant Micropositioning Stage with Remote Center of Motion