Abstract:An indirect tensile testing method is proposed to measure the full dynamic tensile stress-strain curve of low strength brittle solids. In this method, the flattened-Brazilian disc (FBD) sample is loaded by modified split Hopkinson pressure bars (SHPB) system. Low amplitude dynamic forces were measured with a pair of piezoelectric force transducers embedded in the incident bar and the transmitted bar. The evolution of tensile stress at the center of the disc sample was determined through finite element analyses using the measured stress in SHPB as inputs. In a traditional Brazilian test, a strain gauge is mounted at the center of the specimen to measure the tensile strain, which is difficult to apply for low strength brittle materials. Thus, two types of non-contact methods, the Digital Image Correlation (DIC) technique and the Laser Gap Gauge (LGG), were used to measure the strain. The DIC method was used to monitor the displacement and the strain map of the specimen during the test, from which the strain at the center of the specimen can be obtained. The accuracy of the DIC results was assessed, and the displacement and strain uncertainties of our system were 0.003 mm and 0.003, respectively. LGG was used to monitor the expansion of the disc perpendicular to the loading axis, from which the average tensile strain is deduced. The numerical simulation revealed that the tensile strain at the center of the specimen is proportional to the average tensile strain and that the ratio is not sensitive to the material elastic parameters. The strain measured through LGG was compared with that measured by the DIC method using photos captured with a synchronized high-speed camera. The result of the LGG method was 20 % smaller than that of the DIC process. However, the latter was limited by the number of frames of the high-speed camera. The feasibility of this methodology was demonstrated using a polymer-bonded explosive (PBX).

A New Method for Strain Measurement in the Tensile Testing of Filamentous Materials

Influence of specimen dimensions and strain measurement methods on tensile stress–strain curves

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

Validity Analysis of Sample Strain Measurement in Dynamic Tensile Experiment

A New Method of Tensile Performance Testing for Materials at High Temperature and High Strain Rate

Strain-gauge method for determination of yield strength of materials

Tensile Testing of Carbon Fiber Multifilament Using an Advanced Video Extensometer Assisted by Dual-Reflector Imaging

A New Method for the Micro-Tensile Testing of Thin Film

A New Method for Uniaxial Tension Test of Polyester Cord

Mesoscopic Tensile Deformation of Steel Cord with Diverse Layered Nonuniformity Based on Microcomputed Tomography Optimizing Simulation Model

Simplified method to identify full von Mises stress-strain curve of structural metals

Advanced Video Extensometer for Non-Contact, Real-Time, High-Accuracy Strain Measurement.

A Tensile Characterization Study of Metal Sheet in Large-Strain

Comparison of measurement precision of strain and Poisson's ratio using contact and non-contact extensometer

Flattened Brazilian Disc Method for Determining the Dynamic Tensile Stress-Strain Curve of Low Strength Brittle Solids

A New Micro-Tensile System for Measuring the Mechanical Properties of Low-Dimensional Materials - Fibers and Films

Enhancement of Strain Measurement Accuracy Using Optical Extensometer by Application of Dual-Reflector Imaging

An experimental investigation of large-strain tensile behavior of a metal sheet

An Experimental Method for Micro-Scale Uniaxial Tension Test

Measurement and Evaluation of Strain Fields in T23 Steel Based on Digital Image Correlation Method

Constant-Load Tester Based on Lever-Rule and Measurement of Strain Hardening Index and Strain Rate Sensitivity Index