Abstract:High performance vibration isolation requirement in the ultra-low frequency band for high precision equipment becomes more and more stringent. An active vibration isolation method is investigated to broaden the frequency band of isolation and improve the performance, in which an electromagnetic suspension is adopted to provide a static lifting force and an active control force. Naturally, the suspension is accompanied by a controllable negative stiffness. Two factors that might cause instability of the suspension system, i.e., the bias current and the base disturbance, are analyzed to give the stable region. The matching relationship between the currents in the upper and lower coils, and the mapping rules among the current, relative displacement, force and stiffness are discussed, respectively. The maximum base disturbance that the system can withstand is analyzed. On the basis of the theoretical analysis, the active position stabilization and vibration control methods are built and the performance is evaluated. Furthermore, experiments were conducted to verify the effectiveness of the active vibration isolation method. Numerical and experimental results demonstrate that the electromagnetic suspension is able to improve the vibration isolation performance in the ultra-low frequency range, where the transmissibility is below 0 dB in the entire frequency band and the initial vibration isolation frequency is less than 1Hz.

Bearing technology of voltage-controlled four-axis electrostatic suspension system with insulated electrodes

Multi-objective Optimization for the Levitation System of the Electrodynamic Suspension Train with HTS Magnets

Displacement measurement of four-axis electrostatical suspension system with insulated electrodes

Stiffness Analysis And Levitation Force Control Of Active Magnetic Bearing For A Partially-Self-Bearing Flywheel System

Nonlinear Control of Active Electrostatic Bearings for Initial Levitation

Initial levitation of an electrostatic bearing system without bias

Design and Analysis of Four Axis Non-Orthogonal Displacement Sensor Circuit

Electrostatic force generation circuit for single-side electrostatic suspension

Two-Degree-of-Freedom Control for Active Magnetic Bearing Flywheel Rotor System Based on Inverse System Decoupling

THE ELECTROSTATIC SUSPENSION BASED ON OPTRONIC FEEDBACK AND A MEASUREMENT OF ELECTROSTATIC FORCES

Feedback Linearization of Active Electrostatic Levitation Systems

Application of an Active Magnetic Bearing and Bearingless Motor System to the Active Vibration Control of a Shaft

Design And Test Of Displacement Transducer For An Electrode-Insulated Electrostatically Suspended Gyroscope

Ultra-low Frequency Active Vibration Isolation in High Precision Equipment with Electromagnetic Suspension: Analysis and Experiment

Modeling of Hybrid Suspension System of Superconducting and Electrostatic Suspension

Research on the Levitation Control System of Electrostatically Suspended Micro-Gyroscope

Novel Magnetic Suspension Platform with Three Types of Magnetic Bearings for Mass Transfer

System-level simulation of levitation control for a micromachined electrostatically suspended gyroscope

Performance Of An Active Electric Bearing For Rotary Micromotors

Design and Analysis of a 2-DOF Electromagnetic Actuator with an Improved Halbach Array for the Magnetic Suspension Platform