Abstract:Existing vibration displacement control strategies in active magnetic bearing (AMB) flexible rotor systems suffer from a trade-off between damping and noise, which makes it difficult for the system to pass the critical speeds of bending modes. To solve this problem, a rotor vibration velocity and acceleration feedback control strategy based on a non-contact velocity sensor technique is proposed in this paper. The non-contact rotor vibration velocity sensor uses the induced electromotive force caused by changes in the air gap reluctance to measure the rotor vibration velocity. First, an analytical model of the sensor was developed and validated by the finite element method. Then, the structure of the vibration velocity and acceleration feedback control was proposed. Analytical and numerical calculations demonstrated that the rotor vibration velocity feedback is more effective for low-frequency vibrations, whereas the acceleration feedback is utilized to deal with resonances of higher-order bending modes and the weak controllability of the rotor system. To avoid excessive control gains at high frequencies, the least mean square algorithm was adopted to extract the synchronous components of the acceleration. Finally, the experiments were carried out in the AMBs flexible rotor test setup. The results showed that the vibration velocity sensor can be used to assist the proportional–integral–derivative controller to obtain extra damping without significantly increasing the current noise. Low-frequency vibrations were significantly reduced by damping from the rotor vibration velocity feedback. The vibrations at the critical speed of the 2nd bending mode were substantially suppressed by the rotor vibration acceleration feedback.

Application of an Active Magnetic Bearing and Bearingless Motor System to the Active Vibration Control of a Shaft

Stiffness Analysis And Levitation Force Control Of Active Magnetic Bearing For A Partially-Self-Bearing Flywheel System

Vibration of Flexible Rotor Systems with Two-Degree-Of-Freedom Pid Controller of Active Magnetic Bearings

Multi-Objective Optimal Design of Μ–controller for Active Magnetic Bearing in High-Speed Motor

Axial Active-Passive Suspension Electromagnetic System in Radial Air Gap for the Maglev Pump.

Two-Degree-of-Freedom Control for Active Magnetic Bearing Flywheel Rotor System Based on Inverse System Decoupling

Principle And Realization Of A 5-Phase Pm Bearingless Motor Drive

Multiobjective Vibration Control for the Noncollocated Active Magnetic Bearings Flexible Rotor Systems

Active Control of Bearing Force Transmissibility for Active Magnetic Bearings-rigid Rotor Systems

Dynamic analysis and vibration control of a rotor-Active magnetic bearings system with base motion

Vibration Control for Active Magnetic Bearing High-Speed Flywheel Rotor System with Modal Separation and Velocity Estimation Strategy

Synchronous Vibration Control for Magnetically Suspended Rotor System Using a Variable Angle Compensation Algorithm.

Suppression of Lateral Vibration in a Shafting System Via an Auxiliary Active Magnetic Bearing with Position Control

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

Vibration Modal Analysis of the Active Magnetic Bearing System

Analysis and Control of Seven-Phase Permanent-Magnet Bearingless Motor with Single Set of Half-Coiled Winding.

Current Compensation Control of Multiple Frequency Vibrations of the Rotor in Active Magnetic Bearing High Speed Motors

Vibration Control of Base-Excited Rotors Supported by Active Magnetic Bearing Using a Model-Based Compensation Method

Decoupling Control for Active Magnetic Bearing High-speed Flywheel Rotor Based on Mode Separation and State Feedback

Feedforward Decoupling Control for Rigid Rotor System of Active Magnetically Suspended High‐speed Motors

Analysis and Comparison of Inductance and Suspension Force for 2-4 Type and 4-2 Type Multiphase Permanent Magnet Bearingless Motors