Abstract:An experimental study is conducted on localized bulging of inflated latex rubber tubes of a range of wall thicknesses and tube lengths, guided by newly emerged analytical results. In the case when the tube has one free closed end that may or may not be subjected to a dead weight, the initiation pressure for localized bulging is determined by a bifurcation condition, and the propagation pressure is determined by Maxwell's equal-area rule. It is shown that after bulge initiation the pressure will decrease monotonically towards, but will never reach, the propagation pressure, and it is when the pressure is sufficiently close to this propagation pressure that rapid propagation of the bulge in the axial direction takes place. It is found that the experimentally observed initiation pressure is around 15% below the theoretical prediction, which is consistent with the fact that bulging initiation is a sub-critical phenomenon and is therefore sensitive to imperfections. The experimentally observed propagation pressure is always very close to the theoretical prediction, which confirms the insensitivity of this pressure to imperfections and demonstrates the predictive power of the material model fitted from our own experiments on equibiaxial stretching. In the other case when the tube is first stretched and then fixed at both ends, bulge initiation takes place in the same manner as in the previous case, but the propagation pressure is no longer determined by Maxwell's equal-area rule. After bulge initiation the pressure will first decrease to a minimum and then rises slowly, and it is on the latter ascending path that the bulge starts to propagate rapidly in the axial direction. A semi-analytical method is proposed for the determination of the minimum pressure. Numerical simulations with the use of the software Abaqus are also conducted to verify the theoretical predictions. (C) 2018 Elsevier Ltd. All rights reserved.

Simulation for Gas-Membrane Interaction of Folded Membrane Tubes During Inflation

Deployment simulation analysis of inflatable membrane structures

CFD simulation of bubble column with vertical bundle internals

Numerical analysis and experimental study on deployment process of coil-folded inflatable tube

Numerical Simulation of Whole Process and States of Tensile Membrane Structure

Drape and Inflatable Mechanics of Membrane Inflatable Structure

Deployment Simulation of Inflatable Structures Based on Improved Spring-mass System

ENERGY-MOMENTUM BASED APPROACH FOR DEPLOYMENT ANALYSIS OF SPACE MEMBRANE STRUCTURES

Experimental Investigation of Deployment of Coil-Folded Inflatable Tube

A Spring-Mass System Based Approach for Deployment Analysis of Inflatable Membrane Structures

Parametric Model Method and Deployment Simulation of Inflatable Antenna Structures

Thermal Distortion Analysis of Inflatable Antenna Structures Considering Inflation Gas

Nonlinear fluid-structure interaction analysis of the compression process of inflatable tube structures

Numerical Study on the Deformation of a Gas Bubble in Uniform Flow

Numerical Simulation of Gas-Liquid Flow Through a 90° Duct Bend with a Gradual Contraction Pipe

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Experimental Research and Numerical Simulation on Static Deformation of Gasbag with Textile Reinforced Composite Lining

An Experimental Study of Localized Bulging in Inflated Cylindrical Tubes Guided by Newly Emerged Analytical Results

Collaborative fold design and deployment simulations of inflatable membrane trusses

Transient compressible flow in a compliant viscoelastic tube

Development simulation of an inflatable membrane antenna based on extended position-based dynamics