Abstract:The non-coaxial stacked holes caused by cutting deformation is a common problem in stack drilling, particularly for low-rigidity structure, and the non-coaxiality in carbon-fibre-reinforced plastic and aluminium (CFRP/Al) stack drilling has not been studied. Because of the non-homogeneous behaviour and poor machinability of CFRP, the non-coaxiality in CFRP/Al stack drilling is significantly different from previous studies on Al/Al stack drilling. Focusing on the non-coaxiality in CFRP/Al stack drilling, this paper proposed the mechanism of the non-coaxiality through both experiments and numerical study. Severe non-coaxiality occurrences were observed in the CFRP/Al stack drilling experiments. To explain the observation, the macroscopic mechanics theory of composite was applied to obtain the engineering constants of composite laminates, which are necessary for the numerical model. This application leads to the development of an optimized simulation model to predict the interlayer gaps and non-coaxiality. The numerical results that predict the non-coaxiality are consistent with the experiments, which verified the rationality of simulation model. Furthermore, the effect of the thrust force and clamping force on both interlayer gaps and non-coaxiality were studied. The interlayer gaps gradually increase with the increase in thrust force but decrease with the clamping force. Moreover, the thrust force has a complicated effect on the non-coaxiality. The non-coaxiality first decreases and subsequently increases with the increase in thrust force, which can be attributed to the "tilt effect" in the lower layer. In addition, the non-coaxiality increases with the clamping force in the simulation experiment range. The work in this paper enables us to understand the particularity of the non-coaxiality in CFRP/Al stack drilling and select the appropriate cutting parameters for CFRP/Al stack drilling.

Modeling and Analysis of the Effect of Preloaded Pressing Force on Gap Formation During the Drilling of Double-Layered Material

Clamping force prediction for automatic drilling of stacked thin-walled workpieces based on finite element method

Modeling and Optimization of Bidirectional Clamping Forces in Drilling of Stacked Aluminum Alloy Plates

Predictive Model for the Interlayer Burr Height During Drilling of Stacked Aluminum Plates

Numerical and theoretical approach to evaluate the clamping force and the interlayer gap extent during drilling of stacked materials

Hole Diameter Variation and Roundness in Dry Orbital Drilling of Cfrp/Ti Stacks

Influence of the Deformation of Riveting-Side Working Head on Riveting Quality

Modeling of Non-Linear Cutting Forces for Dry Orbital Drilling Process Based on Undeformed Chip Geometry

An Analytical Model to Predict Interfacial Burr Height for Metal Stack Drilling

The Optimal Clamping Force Option for Robotic Drilling of Stacked Aluminum Sheets Based on Shell Theory

The interlayer gap and non-coaxiality in stack drilling

Influence of Cooling/lubrication Conditions on the Drilling Quality and Thrust Force of CFRP/Al Stacks

Experimental Studies of Process Parameters for Interfacial Burr in Dry Drilling of Stacked Aluminum Alloy Sheets

Aerostructural Assembly Deformation Prediction Considering Drilling-Induced Stresses

High reliability model of mechanical response in drilling of CFRP/Al stacks

! Investigation on the Non-Coaxiality in the Drilling of Carbon-Fibre-reinforced Plastic and Aluminium Stacks

Effect of Drilling Parameters and Tool Geometry on Drilling Performance in Drilling Carbon Fiber–reinforced Plastic/titanium Alloy Stacks

Press-fit analysis of multilayer interference fit

Effect of drills with different drill bits on delamination in drilling composite materials

Deformation Prediction of Aero-Structural Assembly Involving Drilling-Induced Stresses

A Review on Drilling of Multilayer Fiber-Reinforced Polymer Composites and Aluminum Stacks: Optimization of Strategies for Improving the Drilling Performance of Aerospace Assemblies