Abstract:The strategy for emission reduction in the P2.5 hybrid system involves the optimization of engine torque, engine speed, catalyst heat duration, and motor torque regulation in a coordinated manner. In addition to employing traditional engine control methods used in HEV models, unique approaches can be utilized to effectively manage emissions. The primary principle is to ensure that the engine operates predominantly under steady-state conditions or limits its load to regulate emissions levels. The main contributions of this paper are as follows: The first is the optimization of catalyst heating stage. During the catalyst heating stage, the system divides it into one or two stages. In the first stage, the vehicle is driven by the motor while keeping the engine idle. This approach stabilizes catalyst heating and prevents fluctuations in air-fuel ratio caused by speed and load changes that could potentially worsen emissions performance. The second stage corresponds to when the engine-driven vehicle heats up its catalyst. The second is the engine control optimization which includes the idle speed control, the minimum intake pressure controls and the oxygen storage capacity control. The third is the motor control optimization. Motor power or power generation can be employed to restrict or stabilize engine load within a certain range so as not to impact original emission levels due to load variations. Start-stop control may also be implemented during this stage but should avoid frequent start-stop cycles until during catalyst heating phase. To prevent emission deterioration caused by frequent start-stop events during the catalyst heating, the calibration of the power threshold in energy management module becomes necessary for minimizing subsequent restarts of the engine; thereby improving overall emissions performance. Experimental results demonstrate that implementing this emission management control approach reduces fuel consumption by 37.6% compared with the traditional vehicles.

A Start-Stop System for Micro-HEV and the Analysis on Its Effects on Vehicle Performance

Start/Stop Control of Hybrid Electric Vehicle Engine

Development Status and Analysis of Start-Stop Technology in Automotive Manufacturers in China

Effects of a start-stop system for gasoline direct injection vehicles on fuel consumption and particulate emissions in hot and cold environments

Parameters Matching of Power System of Micro Hybrid Electric City Bus

Research on the Pollutant Reduction Control for P2.5 Hybrid Electric Vehicles

Research on the Energy Control of a Dual-Motor Hybrid Vehicle During Engine Start-Stop Process

The development of the fuel saving control strategy for 48 V P0 system: Design and experimental investigation

Analysis and Control of Engine Starting Process Based on a Novel Single-Motor Power-Reflux Hybrid Electric Vehicle

Study of Idling Operation in Gasoline Engine for Hybrid Electric Vehicle

Study On Stability Of Vehicle Mass Analysis System

Optimal Engine Starts of an Input-Split Hybrid Electric Vehicle

Active Damping Control of Start-up Process for Hybrid Vehicle

A Pneumatic Hybrid System with an Integrated Compressor/Expander Unit for Commercial Vehicles

Cost and Effectiveness Study of Hybrid Electric Vehicle Technologies Based on China Data

The impacts from cold start and road grade on real-world emissions and fuel consumption of gasoline, diesel and hybrid-electric light-duty passenger vehicles

Research of Intelligent Automotive Alternator Control System to Reduce the Fuel Consumption

Investigation of Gasoline Engine Cold-Start and Warm-up for Parallel Hybrid Electric Vehicle

Life cycle energy and emission analysis of remanufacturing starters for passenger cars

An Efficient Energy Regeneration System for Diesel Engines

Effect of idle-start-go on the economy and emissions of gasoline vehicles