Abstract:The strategy for emission reduction in the P2.5 hybrid system involves the optimization of engine torque, engine speed, catalyst heat duration, and motor torque regulation in a coordinated manner. In addition to employing traditional engine control methods used in HEV models, unique approaches can be utilized to effectively manage emissions. The primary principle is to ensure that the engine operates predominantly under steady-state conditions or limits its load to regulate emissions levels. The main contributions of this paper are as follows: The first is the optimization of catalyst heating stage. During the catalyst heating stage, the system divides it into one or two stages. In the first stage, the vehicle is driven by the motor while keeping the engine idle. This approach stabilizes catalyst heating and prevents fluctuations in air-fuel ratio caused by speed and load changes that could potentially worsen emissions performance. The second stage corresponds to when the engine-driven vehicle heats up its catalyst. The second is the engine control optimization which includes the idle speed control, the minimum intake pressure controls and the oxygen storage capacity control. The third is the motor control optimization. Motor power or power generation can be employed to restrict or stabilize engine load within a certain range so as not to impact original emission levels due to load variations. Start-stop control may also be implemented during this stage but should avoid frequent start-stop cycles until during catalyst heating phase. To prevent emission deterioration caused by frequent start-stop events during the catalyst heating, the calibration of the power threshold in energy management module becomes necessary for minimizing subsequent restarts of the engine; thereby improving overall emissions performance. Experimental results demonstrate that implementing this emission management control approach reduces fuel consumption by 37.6% compared with the traditional vehicles.

Start/Stop Control of Hybrid Electric Vehicle Engine

Fuzzy Logical Control Algorithm Based on Engine On/Off State Switch for Hybrid Hydraulic Excavator

Study of Idling Operation in Gasoline Engine for Hybrid Electric Vehicle

Dynamic Coordinated Control for a Full Hybrid Electric Vehicle with Single Motor

Research on the Pollutant Reduction Control for P2.5 Hybrid Electric Vehicles

Analysis and Control of Engine Starting Process Based on a Novel Single-Motor Power-Reflux Hybrid Electric Vehicle

Investigation of Gasoline Engine Cold-Start and Warm-up for Parallel Hybrid Electric Vehicle

Research on the Energy Control of a Dual-Motor Hybrid Vehicle During Engine Start-Stop Process

Optimal Engine Starts of an Input-Split Hybrid Electric Vehicle

Active Damping Control of Start-up Process for Hybrid Vehicle

Hierarchical energy management strategy for plug-in hybrid electric powertrain integrated with dual-mode combustion engine

Hierarchical control for a full hybrid vehicle with single motor and double clutches

Coordinated Clutch Slip Control for the Engine Start of Vehicles with P2-hybrid Automatic Transmissions

The Control Strategy for a New Full Hybrid Powertrain Structure

Control method of engine auxiliary braking for hybrid electric vehicles

Economical Launching and Accelerating Control Strategy for a Single-Shaft Parallel Hybrid Electric Bus

Fuel economy optimization of diesel engine for plug-in hybrid electric vehicle based on equivalent operating points

Hierarchical Control Strategy for the Hybrid Electric Propulsion System of a Flying Car with Engine Start-Stop System and Dynamic Coordination

The Coordinated Control Strategy of Engine Starting Process in Power Split Hybrid Electric Vehicle Based on Load Observation

The development of the fuel saving control strategy for 48 V P0 system: Design and experimental investigation

Dynamic coordinated control for hybrid electric vehicles in the process of engine torque abrupt change