Abstract:The strategy for emission reduction in the P2.5 hybrid system involves the optimization of engine torque, engine speed, catalyst heat duration, and motor torque regulation in a coordinated manner. In addition to employing traditional engine control methods used in HEV models, unique approaches can be utilized to effectively manage emissions. The primary principle is to ensure that the engine operates predominantly under steady-state conditions or limits its load to regulate emissions levels. The main contributions of this paper are as follows: The first is the optimization of catalyst heating stage. During the catalyst heating stage, the system divides it into one or two stages. In the first stage, the vehicle is driven by the motor while keeping the engine idle. This approach stabilizes catalyst heating and prevents fluctuations in air-fuel ratio caused by speed and load changes that could potentially worsen emissions performance. The second stage corresponds to when the engine-driven vehicle heats up its catalyst. The second is the engine control optimization which includes the idle speed control, the minimum intake pressure controls and the oxygen storage capacity control. The third is the motor control optimization. Motor power or power generation can be employed to restrict or stabilize engine load within a certain range so as not to impact original emission levels due to load variations. Start-stop control may also be implemented during this stage but should avoid frequent start-stop cycles until during catalyst heating phase. To prevent emission deterioration caused by frequent start-stop events during the catalyst heating, the calibration of the power threshold in energy management module becomes necessary for minimizing subsequent restarts of the engine; thereby improving overall emissions performance. Experimental results demonstrate that implementing this emission management control approach reduces fuel consumption by 37.6% compared with the traditional vehicles.

Study of Idling Operation in Gasoline Engine for Hybrid Electric Vehicle

Study of a Hybrid Pneumatic-Combustion Engine under Steady-State and Transient Conditions for Transport Application

Investigation of Gasoline Engine Cold-Start and Warm-up for Parallel Hybrid Electric Vehicle

Start/Stop Control of Hybrid Electric Vehicle Engine

Optimization Control Strategy for Engine of Hybrid Electric Vehicle

Study on the engine start/stop control strategy of hybrid vehicles

Enhancing the Fuel Economy and Emissions Performance of a Gasoline Engine-Powered Vehicle with Idle Elimination and Hydrogen Start

Analysis and Control of Engine Starting Process Based on a Novel Single-Motor Power-Reflux Hybrid Electric Vehicle

Idle Speed Control of a 4-Cylinder Automotive Engine Using Hybrid System Method

Performance of a hybrid hydrogen-gasoline engine under various operating conditions

Influence of Different Volume Percent Hydrogen/Natural Gas Mixtures on Idle Performance of A Cng Engine

Research on the Pollutant Reduction Control for P2.5 Hybrid Electric Vehicles

Experimental study on the optimization of operating conditions for hybrid powertrain gasoline engines

Fuel economy optimization of diesel engine for plug-in hybrid electric vehicle based on equivalent operating points

Optimal Engine Starts of an Input-Split Hybrid Electric Vehicle

A study on the drivability of hybrid electric vehicle

A Start-Stop System for Micro-HEV and the Analysis on Its Effects on Vehicle Performance

Idling Performance of a Hydrogen-blended Methanol Engine at Lean Conditions

Active Damping Control of Start-up Process for Hybrid Vehicle

Research on a pneumatic hybrid engine with regenerative braking and compressed-air-assisted cranking

Research on Engine Bench Experiments of Hybrid Engine Electronic Control Unit