Abstract:The metallurgical properties of blast furnace slag changed when high alumina iron ore was used extensively due to the resulting changes of the molten slag microstructure. In the study, based on typical CaO–MgO–SiO2–Al2O3 slag systems with different w(Al2O3) content, molecular dynamics simulation was used to calculate the microstructural properties of particles in the high-temperature slag system, such as bond length, partial radial distribution function, coordination numbers, and diffusion coefficient. In addition, X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectroscopy, and 27Al solid-state magic angle spinning nuclear magnetic resonance (27Al SS MAS NMR) were used to detect and analyze the samples. The comprehensive calculations and experimental results show that increasing w(Al2O3) can enhance the structural stability of each ion pair, and the strength of the structural stability is such that Si–O > Al–O > Mg–O > Ca–O. The self-diffusion coefficients are as follows: Mg2+ > Ca2+ > Al3+ > Si4+, which leads to the transformation of the [SiO4]4−(Q0), [Si2O7]6−(Q1) and [Si2O6]4−(Q2) structural units to [Si2O5]2−(Q3). The degree of polymerization of slag increased as well as the stability of the structural units. Moreover, the coordination of Al will change from the [AlO6]9−octahedral structure of six-coordinated Al to the [AlO5]7−pentahedral structure of five-coordinated Al and the [AlO4]5−tetrahedral structure of four-coordinated Al. It was also found that the content of non-bridge oxygen in the whole slag system decreased continuously, leading to the increasing degree of polymerization of slag, and the experimental results were consistent with the molecular dynamics calculation.

Aluminium induced sub-microsized α-Al2O3 platelets in the soda-lime-silica glass

Aluminium Induced Sub-Microsized <i>α</i>-Al<sub>2</sub>O<sub>3</sub> Platelets in the Soda-Lime-Silica Glass

Novel temperature dependent process for α-Al2O3 platelets

Morphology-controlled Synthesis of Α-Alumina Microplatelets Through an Additive-Assisted Molten Salt Reaction

Preparation of alumina ceramic template by the molten salt method

Synthesis of thin alpha alumina platelets with a large aspect ratio

Effect of Mass Fraction of CeO2 on Leaching Resistance of Sodium Aluminosilicate Glass

A Modified Random Network Model for P2O5–Na2O–Al2O3–SiO2 Glass Studied by Molecular Dynamics Simulations

Effect of Al2O3 on the Molten Slag Microstructure Information by Molecular Dynamics Simulation and Experimental Analysis

The Role of Phosphate in the Glass Forming Region, Structure and Mechanical Properties for the SiO2-Al2O3-P2O5 System Contains High-Aluminum

Influence of Al2O3/SiO2 ratio in multicomponent LNAS glasses and glass-ceramics on the crystallization behavior, microstructure and mechanical performance

Preparation and microstructure properties of Al-doped TiO2–SiO2 gel-glass film

Size control of α-Al2O3 platelets synthesized in molten Na2SO4 flux

Preparation And Characterisation Of Al2o3 Film On Hollow Glass Microspheres By The Sol-Gel Process

Tuning the hardness and crack resistance through liquid–liquid phase separation in an aluminosilicate glass

Mg and Al mixed effects on thermal properties in aluminosilicate glasses

Preparation of platelet CaMg2Al16O27 (CM2A8) grains via adjusting MgO and Al2O3 contents

Properties and microstructure evolution of unfired Al–Si incorporated Al2O3–C slide plate materials with trace nano-Al2O3 particles

The size-effect of Al2O3 on the sinterability, microstructure and properties of glass-alumina composites

Study of the Synthesis of Α-Al_2o_3 Platelet Crystal by Anhydrous Potassium Alum with the Molten Salt Method

Size Control of α-Al<sub>2</sub>O<sub>3</sub>Platelets Synthesized in Molten Na<sub>2</sub>SO<sub>4</sub>Flux