Abstract:Validation of land surface emissivity (LSE) is very important for assessing the accuracy of remote sensing products and understanding the potential and limitations of retrieval methods. Currently, a commonly used method for obtaining in situ spectral emissivity at ground level is to use a portable Fourier Transform Infrared (FTIR) spectrometer, such as the Model 102F Portable Field Spectrometer. However, since complicated procedures are necessary to ensure the accuracy of measured spectral emissivity, the traditional measuring methods for the 102F FTIR, are usually time-consuming. Additionally, a time-consuming process also means the thermal environment can change, which can further decrease the accuracy of the measurement. A prior knowledge of the sample emissivity in certain wavelength intervals is also necessary for the calculations in the current software package for the 102F FTIR, which makes the performance of the estimated LSEs highly dependent on the accuracy of this prior knowledge. To overcome the limitations in measuring LSE with the 102F FTIR, this paper presents a new solution using well-designed ancillary equipment and an optimized temperature and emissivity separation algorithm. The ancillary equipment consists of 4 major parts and is mainly designed for rapidly switching the sample and the diffuse gold-plate using a remote control. As no extra manual adjustments are necessary in our method, it will obviously decrease the risk of thermal infrared environmental change during measurements. In addition, by using our ancillary equipment, the reflected environmental radiance over the height surface is now measurable instead of using the approximations at the ground. By using a Wavelet-Transformed Temperature and Emissivity Separation (WTTES) algorithm, the surface temperature and the spectral emissivity are now simultaneously obtained without any prior knowledge, thus making the retrievals more reasonable. According to the experiments, our method is more efficient and accurate for measuring the spectral emissivity through the 102F FTIR spectrometer.

Experimental research on the spectral emissivity measurement based on FTIR

Measurement of Spectral Emissivity Based on FT-IR

Measurement of Spectral Emissivity of Object Based on Infrared Radiometer

Quantitative Infrared Spectroscopy of Environmentally Sensitive and Rough Materials.

Study of Radiometric Calibration Methods on FTIR Spectrometer

Field Measurement Methods for Thermal Infrared Spectral Emissivity of Terrestrial Surface Materials

Fourier Transform Spectrometer for Spectral Emissivity Measurement in the Temperature Range Between 60 and 1500°C

Thermal Emissivity Measurement with Two-temperature Method

[Experimental Investigation of Infrared Spectral Emissivity of Copper at 300~1123 K].

Experimental Investigation of Infrared Spectral Emissivity of Copper at 300~1 123 K

Experimental Investigation of Infrared Spectral Emissivity of Copper at 300 similar to 1 123 K

The Calibration of Instrument Response Function During Passive FTIR Measurement

Fast and accurate measurement of spectral emissivity with a portable field infrared spectrometer: ancillary equipment and methods

[The Linearity Analysis of Ultrahigh Temperature FTIR Spectral Emissivity Measurement System].

Study on the Method of Ftir Spectrum Non Linear Multiple Point Calibration

Initial Study of A New Method for Measuring the Temperature of Hot Gas by Ftir Spectrometry

An Emissivity Measurement Apparatus for Near Infrared Spectrum

Non-Contact Measurement of the Spectral Emissivity Through Active/Passive Synergy of CO2 Laser at 10.6 Μm and 102F FTIR (fourier Transform Infrared) Spectrometer

Measurement System for FT-IR Infrared Spectral Emissivity of Solid Surface at Ultra-High Temperature

Measurement of High-Temperature Spectral Emissivity Using Integral Blackbody Approach

Measurement of emissive spectral fingerprinting for material identity by the fourier transform infrared remote sensing technique