Abstract:Validation of land surface emissivity (LSE) is very important for assessing the accuracy of remote sensing products and understanding the potential and limitations of retrieval methods. Currently, a commonly used method for obtaining in situ spectral emissivity at ground level is to use a portable Fourier Transform Infrared (FTIR) spectrometer, such as the Model 102F Portable Field Spectrometer. However, since complicated procedures are necessary to ensure the accuracy of measured spectral emissivity, the traditional measuring methods for the 102F FTIR, are usually time-consuming. Additionally, a time-consuming process also means the thermal environment can change, which can further decrease the accuracy of the measurement. A prior knowledge of the sample emissivity in certain wavelength intervals is also necessary for the calculations in the current software package for the 102F FTIR, which makes the performance of the estimated LSEs highly dependent on the accuracy of this prior knowledge. To overcome the limitations in measuring LSE with the 102F FTIR, this paper presents a new solution using well-designed ancillary equipment and an optimized temperature and emissivity separation algorithm. The ancillary equipment consists of 4 major parts and is mainly designed for rapidly switching the sample and the diffuse gold-plate using a remote control. As no extra manual adjustments are necessary in our method, it will obviously decrease the risk of thermal infrared environmental change during measurements. In addition, by using our ancillary equipment, the reflected environmental radiance over the height surface is now measurable instead of using the approximations at the ground. By using a Wavelet-Transformed Temperature and Emissivity Separation (WTTES) algorithm, the surface temperature and the spectral emissivity are now simultaneously obtained without any prior knowledge, thus making the retrievals more reasonable. According to the experiments, our method is more efficient and accurate for measuring the spectral emissivity through the 102F FTIR spectrometer.

Error analysis for emissivity measurement using FTIR spectrometer

Analysis of Multi-Factor on Measurement Improvement of an Infrared Imager in Low-Temperature Environments

Measurement of Spectral Emissivity of Object Based on Infrared Radiometer

Non-target Factor Impacts on Thermal Hyperspectral Measurement

Measuring Thermal Emission Near Room Temperature Using Fourier-Transform Infrared Spectroscopy

Comparison of different water infrared emissivity retrieval methods with the theoretical model

An optimized emissivity and temperature separation from hyperspectral thermal infrared data

Thermal-emission measurements near room temperature using Fourier-transform infrared spectroscopy

Thermal Emissivity Measurement with Two-temperature Method

Analyses of Spectral Emissivity in Radiation Temperature Measurement

Uncertainty Analysis of Spectral Emissivity Measurement Method

Correcting Thermal-Emission-induced Detector Saturation in Infrared Spectroscopy

Calculation of Infrared Temperature Measurement on Non-Lambertian Objects

Fast and accurate measurement of spectral emissivity with a portable field infrared spectrometer: ancillary equipment and methods

Infrared emissivity measurement methods considering target reflective characteristics

Algorithm of Emissivity Spectrum and Temperature Separation Based on TASI Data

Peculiarities Of Near-Room-Temperature Thermal-Emission Measurements Using Ftir Spectroscopy

Algorithm research of building materials emissivity extracting.

Analysis on Influence Factors for Transmission Measurements of Absorbing and Scattering Media Based on the Internal Optical-Path of FTIR Spectrometer

ANALYSIS AND EXTRACTION OF EMISSIVITY INFORMATION FROM AN AIRBORNE THERMAL INFRARED MULTISPECTRAL SCANNER (ATIMS) DATA

IR radiometer sensitivity and accuracy improvement by eliminating spurious radiation for emissivity measurements on highly specular samples in the 2 to 25 μm spectral range