Abstract:In a regular FAIMS system, a carrier gas is used to drive samples through the drift tube. Thus, high consumption of sample and carrier gas can be expected, especially when multi-cycle detection is needed for high precision detection. In this study, a novel re-circulation mode FAIMS was developed. Ion separation capacity and limit of detection (LOD) of this FAIMS system were investigated. The stability of this FAIMS system was also studied by changing the flow rate of the carrier gas. Using this newly designed re-circulation mode FAIMS system, the detection results of o-, p- m- xylenes in pure nitrogen and helium/nitrogen mixtures were compared. The sample and the carrier gas reserve time which ensure the success of multi-cycle detection was examined. The characteristic parameters (alpha(2), alpha(4)) and their deviation were also precisely calculated through 18 CV-DV spectra. Results show that 0.6 ng o-xylene can be detected in a 25 ml closed loop re-circulation arrangement. The effective detection time is 6.2 min in this detection process. In fact, the sample and the carrier gas used in this experiment are 70 and 826 times less than a regular open loop FAIMS system respectively. The peak position and the full width at half-maximum (FWHM) of the obtained CV-DV spectra stay almost unchanged during th.entire experiment process. The ion signal peaks can be fitted with a Gauss curve, which means that the stability of the carrier gas flow rate fully meet the requirement for on-site detection. Furthermore, the use of a helium modifier is studied and proved to be an effective method to improve the detection capacity of the FAIMS for VOCs. In conclusion, the gas-saving re-circulation design along with the gas modifiers provide new opportunities for FAIMS systems to be applied on-site high precision chemical detection. (C) 2016 Elsevier B.V. All rights reserved.

Monocyclic Aromatic Compounds Detection with High Field Asymmetry Waveform Ion Mobility Spectrometry

Gas Modifier Assisted Re-Circulation Mode High-Field Asymmetric Waveform Ion Mobility Spectrometry (FAIMS)

An Intelligent Detection Method for High-Field Asymmetric Waveform Ion Mobility Spectrometry

Rapid Measurement of Synthetic Pigments by Thermal Desorption-High Field Asymmetric Waveform Ion Mobility Spectrometry (faims) Technology

Identification of different perfumes based on microchip-based FAIMS technique

Volatile Phenolic Compounds Detection by 2D Scanning High-Field Asymmetric Waveform Ion Mobility Spectrometry

A Hybrid Wireless Electrodeless QCM-D for the Discrimination of Volatile Organic Compounds

High-Field Asymmetric Waveform Ion Mobility Spectrometry Based on MEMS

Generation and Ion Separation Behavior of Clipped-Sinusoidal Waveform for High-Field Asymmetric Waveform Ion Mobility Spectrometry

Separation of Ions from Volatile Organic Compounds Using High-Field Asymmetric Waveform Ion Mobility Spectrometry-Mass Spectrometer

Detection of Benzene Series by Two-Dimensional FAIMS Technique.

Based on SIMION Simulation to Identify Peaks of High-Field Asymmetric Waveform Ion Mobility Spectrometry Spectra

Comprehensive Theoretical Analysis and Experimental Exploration of Ultrafast Microchip-Based High-Field Asymmetric Ion Mobility Spectrometry (FAIMS) Technique.

High Sensitivity Field Asymmetric Ion Mobility Spectrometer.

Detection of Toluene, Methanol and Formaldehyde Using Corona Discharge Ion Mobility Spectrometry

Monolithic Integration of Tandem-Faims Based on Overlapping Ion Peak Separation and Weak Ion Peak Discovery for Gas Detection

Detection of Chemical Warfare Agent Simulants by UV Photoionization High-Field Asymmetric Ion Mobility Spectrometry

Design of biochemical sensor based on high-Field Asymmetric Ion Mobility Spectrometry

Faims of Trace Volatile Organic Compounds

Study on key measurement and control modules of high-field asymmetric waveform ion mobility spectrometer

Identification of Toxic VOC Pollutants Using FAIMS.