Abstract:Gas or liquid flow through small channels has become more and more popular due to the micro-electromechanical systems (MEMS) fabrication technologies such as micro-motors, electrostatic comb-drive, micro-chromatographs, micro-actuators, micro-turbines and micro-pumps, etc. The flow conditions in and around these systems are always recognized as typical transitional regimes. Under these conditions, the mean free path of gas molecules approaches the characteristic scale of the micro-devices itself, and due to the little collisions the heat and momentum cannot equilibrate between the wall and fluids quickly. Couette flow is a simple and critical model in fluid dynamics which focuses on the mechanism of the heat transfer in shear-driven micro-cavities or micro-channels. Despite numerous work on the numerical solutions of the Couette flow, how to propose stable and accurate slip boundary conditions in rarefied flow conditions still remains to be elucidated. In this paper, converged solutions for steady-state micro Couette flows are obtained by using conventional Burnett equations with a set of modified slip boundary conditions. Instead of using the physical variables at the wall, the modified slip conditions use the variables at the edge of the Knudsen layer based on a physically plausible assumption in literature that Knudsen layer has a thickness only in the order of a mean free path and molecules are likely to travel without collision in this layer. Numerical results for non-dimensional wall shear stress and heat flux are compared with those of the DSMC solutions. Although there are not much improvement in the accuracy by using this modified slip conditions, the modified conditions perform much better than the unmodified slip conditions for numerical stabilization. All results show that the set of conventional Burnett equations with second order modified conditions are proved to be an appropriate model for the micro-Couette flows.

Numerical simulation of coiled adiabatic capillary tubes in CO2 transcritical systems with separated flow model including metastable flow

Numerical Simulation and Experimental Study of Capillary Tubes

Numerical Analysis of the Micro-Couette Flow Using a Non-Newton–fourier Model with Enhanced Wall Boundary Conditions

Numerical Simulation of Gases over Flat Plate Using Two-Temperature Nonlinear Coupled Constitutive Relations

Reference temperature correction and dimensionless number analysis for heat transfer of supercritical CO2 in horizontal tubes

Frictional Resistance Investigation of Sco2 and a Semi-Empirical Friction Factor Correlation Based on Wall-of-the-law

An Assessment of Friction Factor and Viscosity Correlations for Model Prediction of Refrigerant Flow in Capillary Tubes

Simulation of Couette Flow Using Conventional Burnett Equations with Modified Slip Boundary Conditions

Comparison Between Homogeneous and Separated Flow Models of Isobutane Flowing Through Adiabatic Capillary Tubes

NUMERICAL CALCULATION OF FLOW IN ADIABATIC CAPILLARY TUBE OF ALTERNATIVE REFRIGERANTS

Modeling and simulation in supersonic three-temperature carbon dioxide turbulent channel flow

Numerical Model Development for Critical Region Flow and Thermodynamic Transitions of CO2 Fluids in Microchannel

Experimental and Simulation Investigation on Heat Transfer Characteristics of In-Tube Supercritical CO2 Cooling Flow

Numerical Simulation of Membrane Separation Characteristics of Supercritical Carbon Dioxide and Water

Investigation on the Adaptivity of the Transcritical CO2 Refrigeration System with a Capillary

Numerical study on flow and heat transfer of S−CO2 in inclined tubes under different flow conditions

A Robust Computational Model for Simulating Supercritical Co2 Non-Equilibrium Condensation Flows

Simulation on the Performance of Adiabatic Capillary Tubes With R410A Refrigerant

Numerical modeling of refrigerants flowing through short tube orifices

Numerical Simulation of Convective Heat Transfer for Supercritical CO2 in Vertical Pipes Using V2F Turbulence Model

Numerical Simulation of Convection Heat Transfer for CO_2 at Supercritical Pressure in Vertical Circular Tube