Abstract:Supercritical CO2 (S-CO2) power cycles have demonstrated significant performance improvements in concentrated solar and nuclear applications. These cycles promise an increase in thermal-to-electric conversion efficiency of up to 50% over conventional gas turbines (Wright, S., 2012, “Overview of S-CO2 Power Cycles,” Mech. Eng., 134(1), pp. 40–43), and have become a priority for research, development, and deployment. In these applications the CO2 is compressed to pressures above the critical value using radial compressors. The thermodynamic state change of the working fluid is close to the critical point and near the vapor–liquid equilibrium region where phase change effects are important. This paper presents a systematic assessment of condensation on the performance and stability of centrifugal compressors operating in S-CO2. The approach combines numerical simulations with experimental tests. The objectives are to assess the relative importance of two-phase effects on the internal flow behavior and to define the implications for radial turbomachinery design. The condensation onset is investigated in a systematic manner approaching the critical point. A nondimensional criterion is established that determines whether condensation might occur. This criterion relates the time required for stable liquid droplets to form, which depends on the expansion through the vapor–pressure curve, and the residence time of the flow under saturated conditions. Two-phase flow effects can be considered negligible when the ratio of the two time scales is much smaller than unity. The study shows that condensation is not a concern away from the critical point. Numerical two-phase calculations supported by experimental data indicate that the timescale associated with nucleation is much longer than the residence time of the flow in the saturated region, leaving little opportunity for the fluid to condense. Pressure measurements in a converging diverging nozzle show that condensation cannot occur at the level of subcooling characteristic of radial compressors away from the critical point. The implications are not limited to S-CO2 power cycles but extend to applications of radial machines for dense, saturated gases. In the immediate vicinity of the critical point, two-phase effects are expected to become more prominent due to longer residence times. However, the singular behavior of thermodynamic properties at the critical point prevents the numerical schemes from capturing important gas dynamic effects. These limitations require experimental assessment, which is the focus of ongoing and future research.

A Robust Computational Model for Simulating Supercritical Co2 Non-Equilibrium Condensation Flows

Experimental and Numerical Investigation on the Dynamic Characteristics of a Lab-Scale Transcritical CO2 Loop

The Prediction of Condensation Characteristics of Supercritical Carbon Dioxide in the Laval Nozzle During Supersonic Flow

Numerical Simulation Study on Influence of Equation of State on Internal Flow Field and Performance of S-CO2 Compressor

Simulation of Mixed Convection Heat Transfer to Carbon Dioxide at Supercritical Pressure

An Investigation of Condensation Effects in Supercritical Carbon Dioxide Compressors

Numerical Simulation on the Flow and Heat Transfer of Supercritical CO2 in Sudden Expansion Pipe under Cooling Condition

Numerical Model Development for Critical Region Flow and Thermodynamic Transitions of CO2 Fluids in Microchannel

Numerical simulation of single bubble condensation in subcooled flow using OpenFOAM

A Computational Study of Convection Heat Transfer to CO2 at Supercritical Pressures in a Vertical Mini Tube

Molecular dynamics simulation of the transport properties and condensation mechanism of carbon dioxide

A potential strategy of carbon dioxide separation using supersonic flows

Improvement of Condensation Model With the Presence of Non-Condensable Gas for Thermal-Hydraulic Analysis in Containment

Numerical Analysis of Supercritical CO2 Flow and Heat Transfer Inside Porous Structures on a Microchip

Numerical methods development for non-equilibrium wet steam condensing flow

Numerical Simulation of Convective Heat Transfer for Supercritical CO2 in Vertical Pipes Using V2F Turbulence Model

Investigation And Modeling Of The In-Tube Heat Transfer Of Fluids At Supercritical Pressure During Heating

Model development and simulation on dropwise condensation by coupling absorption theory in the presence of non-condensable gas (NCG)

Effects of Liquid Film Waviness, Suction, and Fog Formation on Condensation in the Presence of Noncondensable Gases

Effect detection of using a modified Redlich-Kwong-Aungier equation of state on the calculation of carbon dioxide flow in a centrifugal compressor