Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Comparison Between Homogeneous and Separated Flow Models of Isobutane Flowing Through Adiabatic Capillary Tubes

Numerical Simulation and Experimental Study of Capillary Tubes

An Assessment of Friction Factor and Viscosity Correlations for Model Prediction of Refrigerant Flow in Capillary Tubes

Numerical simulation of coiled adiabatic capillary tubes in CO2 transcritical systems with separated flow model including metastable flow

Simulation of Couette Flow Using Conventional Burnett Equations with Modified Slip Boundary Conditions

Adiabatic capillary tube flows of n-butane and isobutane

NUMERICAL CALCULATION OF FLOW IN ADIABATIC CAPILLARY TUBE OF ALTERNATIVE REFRIGERANTS

An Approximate Analytic Model for Flow Through Capillary Tubes

One-order Integral Model of Refrigerants Flowing Through Adiabatic Capillary Tubes

Analysis on the Adiabatic Flow of R407C in Capillary Tube

A generalized correlation for the characteristics of adiabatic capillary tubes

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Simulation on the Performance of Adiabatic Capillary Tubes With R410A Refrigerant

Advanced model for a non-adiabatic capillary tube considering both subcooled liquid and non-equilibrium two-phase states of R-600a

Numerical modeling of refrigerants flowing through short tube orifices

General integral model of capillary tubes

Metastable flow of R12 through capillary tubes

A New Heat Transfer Model for Flow Boiling of Refrigerants in Micro-Fin Tubes

Numerical Gas-Liquid Stratified Flow Regime Model On Evaporation Heat Transfer In Horizontal Microfin Tubes

THEORETICAL MODEL OF EVAPORATION HEAT TRANSFER BASED ON GAS-LIQUID ANNULAR FLOW OF HORIZONTAL MICROFIN TUBE

Buoyancy-aided convection flow in a heated straight pipe: comparing different asymptotic models