Abstract:The breakdown and recovery characteristics of the highly repetitive (≤100 kHz) and short nanosecond (∼10 ns) pulsed discharge were investigated. It was found that if one pulse of 40 kV is applied, the air gap between two conical electrodes for a reliable breakdown is only 1 mm; however, if 1000 same pulses are repetitively applied, the longest gap that can be broken down dramatically increases with the increase in the repetitive rate and it reaches 90 mm at 100 kHz. During the preceding pulses that do not cause the breakdown of the gap, long streamers develop from both conical electrodes and nearly bridge the gap, which provides the residual and decaying plasma channels for the rapid breakdown of 90-mm gap in the following pulses, which was experimentally proved to be unique in the extremely non-uniform electric field. The voltage recovery was determined with the two-pulse method and found that the physical processes of the voltage recovery after the short nanosecond pulsed breakdown are similar to that after the microsecond pulsed breakdown, but the time needed for a full recovery in the gas density, in between 50 and 100 μs, is shorter by three orders than that after the microsecond pulsed breakdown. The faster recovery in the gas density may be understood from the small energy of 36 mJ in one nanosecond pulse, which does not induce a high perturbation in the gas density. The evolution in the discharge mode in a 15-mm gap, from corona to diffuse and finally to multichannel spark, with the applied voltage and the repetitive rate was observed. The formation of the multichannel spark is due to the limited energy per pulse that is not enough to heat the primary channel to high conductivity for the collapse of the gap voltage.

Stability of high current diode under 100-nanosecond-pulse voltage

Pulsed Corona Generation Using a High-Power Semiconductor Diode Switch

Effect of Nano- to Millisecond Pulse on Dielectric Barrier Discharges

Investigation on the Characteristics of Dielectric Barrier Surface Discharge Driven by Repetitive Nanosecond Pulses in Airflows

A Compact Repetitive High-Voltage Nanosecond Pulse Generator for the Application of Gas Discharge

The Effect of Initial Electrons Generation Approaches on Nanosecond Pulsed Breakdown Characteristics.

Ionization wave propagation characteristics under different polarity of pulse waveforms in micro-DBD device driven by bipolar nanosecond pulse waveform

Computational Study of Cathode Plasma Dynamics in High-Power Electron Beam Diodes by Particle-in-cell Simulations

The Vacuum Flashover Characteristics Of Dielectrics Under Ns Pulse

The influencing factors of nanosecond pulse homogeneous dielectric barrier discharge in air.

Experimental Study of Nanosecond Pulsed Barrier Discharges in Air Manipulated by Pulse Width

Breakdown, Discharge Modes, and Gaseous Recovery of Atmospheric Air with Repetitive 10 Ns Pulses

Research on Source of High Dose Rate Gamma-Ray with Short Pulse Duration

Characterization of plasma expansion dynamics in a high power diode with a carbon-fiber-aluminum cathode

The Influence of Pulse Repetition Rate on the Behavior of Nanosecond Pulsed Dielectric Barrier Discharges

Characteristics of Nanosecond Pulse Surface Dielectric Barrier Discharge in Air Flow

High Voltage Nanosecond Pulse Generator Based on Pseudospark Switch and Diode Opening Switch.

High Voltage Pulser with a Fast Fall-Time for Plasma Immersion Ion Implantation.

A Novel Pulse Compression Diode for Picosecond Pulse Generation

Failure Behavior of Dielectric Films for Peaking Capacitor Subjected to Surface Flashover under Nanosecond Pulses

An Uniform DBD Plasma Excited by Bipolar Nanosecond Pulse Using Wire-Cylinder Electrode Configuration in Atmospheric Air.